Furinno FNBQ-22121 User manual

Assembly Instruction
Customer Service
Tel/Fax: [phone]
Toll Free: 773.299.8111 (Mon - Fri 9am - 5pm)
Email: [email protected]
WARNING:
>This unit has been designed to support the
maximum loads shown. Exceeding these
load limits could cause sagging, instability,
product collapse, and/or serious injury.
>DO NOT allow children to climb on unit.
>Put heavier items on lower shelves.
its Space. its Budget
www.furinno.com
Approx. 30 minutes
Recomm. 2 Person
No Tools Required
STEP 5 STEP 6
STEP 4
Recommended Maximum Weight
Furinno Adjustable Bathroom
Corner Shelf
FNBQ2212120140401
MODEL : FNBQ-22121
22.8”(W) x 47”-88.5”(H) x 15.75”(D)
22.8”(W) x 63”-118” (H) x 15.75”(D)
DIMENSION :
pcs
pcs
4.1 Insert Tray Stopper(7)
into the holes on Upper
Trays(4), as shown.
4.2 Insert the Tray Hook(8)
into the holes on Lower
Tray(5), as shown.
Adjust the unit height
inaccordance to the space
height before assemble.
**Unit length must at least
longer than space height by
2 inches.**
First fix upper Suction
Plate to the ceiling and
slowly slide in the lower
suction plate.
This unit can be assembled
to two sets of height range,
as shown.
If the distance between
ceiling and ground is
shorter, Lower Pole(1)
can be optional.
Ceiling
15Lbs
Floor

1
2
3
2pcs
1pcs
1pcs
4
5
6
3pcs
7
8
9
3pcs
1pcs
2pcs
10 5pcs
1pcs
1pcs
STEP 2 STEP 3
IMPORTANT: Adjust the unit height
in accordance to the space height
before assemble.
**Unit length must at least longer
than space height by 2 inches.**
Install Suction Plate(9)onto
one end of Upper Pole(3).
Pull out the inner pole of
Center Pole(2) and connect
to Upper Pole(3).
Note:Adjust to desired height
through the turning knob on
Center Pole(2).
As shown:Assemble the
unit from bottom to top.
Adjust the position of
Trays(4)&(5)and Towel
Bar(6)with Rubber Ring(10).
Connect Lower Pole(1)
to the assembled unit.
STEP 1
Lower Pole
Center Pole
Upper Pole
Upper Tray
Lower Tray
Tower Bar
Tray Stopper
Tray Hook
Suction Plate
Rubber Ring
Release
No Hardware List Qty
USEFUL HINTS BEFORE YOU START:
1. Read each step carefully before starting.
2. It is important that each step is performed in correct order to avoid difficulties.
3. Identify, sort and count the parts before assembly.
4. Assemble your furniture on packaging cardboard to prevent scratch or damage.
5. Clean the product with mild cleanser using soft damped cloth. Do not use harsh or abrasive cleanser.
6. Using uncompatible hardware might cause damage to product.