FutureSmart MDC-108 User manual

INSTALLATION GUIDE
MDC-108
Coax Distribution Module
12382 south gateway park place, 700, draper, utah 84020
1.801.617.3100
www.futuresmart.com

FutureSmart
The FutureSmart MDC-108 Coax Distribution Module provides distribution of one
incoming coax signal (TV or Cable TV) to 8 locations, and Satellite TV to 2
locations. Please be sure to review this installation guide carefully prior to
installation.
Installing the MDC-108 Coax Distribution Module
Connecting TV, and Cable TV
1. Run a RG6 coax cable from the video source (antenna or Cable TV)
to the MDC-108 coax distribution module.
2. Connect the RG6 coax cable to the input on the rear of the MDC-108
coax distribution module.
Input for
Antenna
Television or
Cable TV
3. Connect the RG6 coax cable running to the rooms to the outputs on
the front of the MDC-108 coax distribution module. If you are using
MDP3 patch modules, use coax patch cords to connect the zones and
the outputs.
8 outputs
MDC-108 Installation Guide Page 1

FutureSmart
MDC-108 Installation Guide Page 2
Connecting Satellite TV (KU Band Only)
1. Run 2 RG6 coax cables from the Satellite Dish to the MDC-108 coax
distribution module. One will be designated as LNB A and the other as
LNB B.
2. Connect the LNB A and LNB B RG6 coax cables coming from the
Satellite dish to the SATV inputs on the back of the MDC-108 coax
distribution module.
SATV Inputs
3. Connect the RG6 coax cable running to the Satellite Receivers in the
rooms to the SATV outputs on the front of the MDC-108 coax distribution
module. If you are using MDP3 patch modules, use coax patch cords to
connect the zones where the receivers are located with the SATV
outputs.
SATV
Out
p
uts