G-Homa EMW302WF User manual

Quick Start
Guide
Type: EMW302WF
1APP Downloading & Installing
2APP User Registration
After installing the G-Homa app, use a
valid email address to register a new
account (If forget password, the email
account is used to verify password.).
Add Device
3
A - Click ‘Add my first device’ on the
page, or click ‘+’ on the top right
corner, then add device to your
account with following procedures.
B - Connecting procedures
Enter App Store or Google Play, download and install G-Homa
app. You can also click the link on G-Homa website - Support
page to download.

C - Add New Device by Manual Mode （AP: Access Point)
IOS system (Step 1): Go to home page of smartphone:
IOS system (Step 2): Back to G-Homa App, click ‘Connected to G-Homa’, choose the
WiFi that you can connect, enter the password to connect.
Android system:

Personalize Your Device
If you met problems when using
devices, you can send a report to
service center. Our team will reply in
1-2 working days.
4
A - User can change device name and device image accordingly.
Notice: System present device name: 101, 102... (e.g. Indoor series), 201, 202...
(e.g. Outdoor series)...
B - Add Timer / Delete Timer: Slide to left
E - Report
C - Alert message D - Firmware update
And

Max. ON Time Setting
When this function is activated, the device will stay ON status no more than
Max. ON hours.
A - Add a New Group
F - Delete device
5
Countdown Setting
6
Group Setting
7

The devices in the same group are in the same setting.
8
B - Group Timer Setting
C - Change Device D - Delete Group
General Setting
A - Change Password / Delete Account
B - Notification Setting
Alert message can be sent to G-Homa
App or Registered Email.

If you have an energy monitoring device, you can click the energy monitoring icon
to enter the interface. You can set the fixed tariff or peak-valley tariff by clicking the
button. To set the tarriff amount please click on the icon next to the technical data.
Caution: when use the peak-valley tariff, please make sure no time period is missing.
9Energy Monitoring Setting (EMW302WF-CTL ONLY)
Delete Data

Volume up the sound of thesmartphone. Go near to the Sound Detector!Once the
device is activated, notification will be pushed.
Notice: Up to 10 sensor devices can be added under a main device.
10 Sound Detector (EMW302WF-SD ONLY)
A - Add Security Component
A - Function Test & Notification
B - Reset Flashing Alarm Icon
11 Home Security (EMW302WF-HS ONLY)

A - Add a New Linkage (If/Then Settings)
Linkage Setting
12
B - Linkage “IF” Setting
Notice: In terms of conditions below, green means ‘And’, orange means ‘Or’, but they
must be in the same color.
C - Reset Flashing Alarm Icon
B - Add Timer (When to alarm/disalarm)

C - Linkage “Then” Setting
D - Delete Linkage