Gama Sonic Denali 229iM60012 User manual

Denali Commercial Solar LED Post
Light with Morph Technology
Part #: 229iM60012
Version 1.1
Instruction Manual

page 2
Thank you for your purchase! GAMA SONIC®solar charged lights are brighter and last
all night with a typical solar charge. Unique design, superior light output and numerous
installation options confirm the outstanding value of our product. GAMA SONIC®has
been recognized as a worldwide leader in the lighting industry for over 20 years.
Technical Assistance/Warranty Claims/Replacement Parts
Toll Free Number: [phone] (only within the US) or www.gamasonic.com
Visit our website or download the latest version of your instruction manual:
www.gamasonic.com or www.gamasonic.com/user-guides
Please read the instruction manual carefully to obtain the best results from your purchase.
What's in the Box
For best results, the solar light must be charged in the “ON” position (High or
Low) for at least 2 days of full direct sunlight.
Gama Sonic’s NEW Morph Solar Panel
Technology is our ground-breaking process
of capturing more power from the sun.
Monocrystalline solar cells are molded to
the surface of the lamp, “morphing” the
lamp into a solar panel.
A = Arm assembly
B = Lamp head
C = Threaded rod
D = Rod cover
C
D
B
A
For optimum light duration throughout the
night, it is very important to mount your
solar lamp in a spot where it will receive
the maximum amount of direct sunlight
throughout the day.
Gama Sonic’s New Morph Technology
Solar Lamp Location

Assembly Instructions
Replacement Parts
Operation Instructions
(follow these instructions for each lamp head)
page 3
SINGLE LAMP HEAD
•Secure the threaded rod (C) to the lamp head (B) by
screwing it in clockwise and tighten with a wrench. (Do
not overtighten).
• Remove the screw cap, nut, and lock washer from the
threaded rod (C).
•Slide the rod cover (D) over the threaded rod (C).
• Slide the threaded rod through the hole in the arm
assembly (A) and secure using the nut.
NOTE: The nut needs to fit into the relief cut of the
arm assembly. Once in there, spin the lamp head (B)
clockwise until the lamp head is securely fastened to
the arm assembly (A).
•Place the lock washer and cap
nut on top of the threaded rod
and tighten.
•Place the arm assembly (A) over a
3” pole and secure by tightening
the four set screws.
•Follow the Operation Instructions
to turn the lamp on.
DOUBLE LAMP HEAD
(requires purchase of an additional lamp)
•Remove the four screws holding the cap on to the top
of both arm assemblies (A).
•On one of the assemblies, remove the bolt and lock
washer from the inside using an open end or socket
wrench.
•Also remove the cap nut and lock washer on the
outside and separate the arm from the center support.
•On the other assembly, remove the plug at the top
from the inside by pushing it out.
• Remove the cap nut and spacer piece.
•Install the arm removed form the first assembly onto
the center support of the second one and secure from
the outside using the lock washer and cap nut.
•Secure from the inside using the lock washer and bolt
and tighten with a wrench.
• Reinstall the cap with the four screws on top of the arm
assembly (A).
•Install the lamp heads utilizing the instructions above
for “SINGLE LAMP HEAD” and repeat for both sides.
Replacement Batteries are available at
www.gamasonic.com or via our Toll Free
number: [phone].
Your lamp uses two of the following battery:
GS32V12A
Turning the lamp on
•Remove the cover over the LED’s by twisting counter
clockwise.
•Move the operation switch to one of the options below
based on your desired performance:
- Low = Softer light, longer duration
- High = brighter light output
Timer Switch
•Using a small flathead screwdriver, turn the arrow to
one of the following settings:
- 0 = Dusk to Dawn operation
- 4,5,6,7,8 = The number of hours the lamp will
operate from Dusk.
•If a number other than 0 is selected, the lamp will
operate for that many hours from dusk and will then
turn off for the remainder of the night.
•Re-attach the cover and twist clockwise to secure.
•Your lamp will operate automatically at dusk.

Replacing the Batteries
(each lamp head has its own set of batteries)
1. Remove the cover over the LEDs by twisting counter
clockwise.
2. Move the operation switch to OFF.
3. Loosen the two screws closest to the LED panel (the screws
will pull out slightly when loose but do not fully remove.
4. The Led Panel will drop down and open the battery
compartment.
5. Unclip the old batteries and remove them from the
compartment.
6. Make sure the new batteries are high quality Li-Ion 3.2V 12Ah
batteries with a matching connector (part# GS32V12A).
7. Clip in the new batteries and secure them in the
compartment.
8. Reinstall the LED panel and turn the lamp back on by
reversing steps 1-3.
Maintenance
Clean the solar panels regularly with a damp towel to guarantee optimum performance. Do not
use any type of solvent for cleaning and be careful not to put too much pressure on the solar
panels while cleaning.
Troubleshooting
If your solar light does not come on as expected despite observance of all the instructions, please try
the following steps:
1. Make sure that the solar lamp is not being affected by any other light source.
2. Ensure the solar lamp is not positioned in the shade during the day.
3. Check that the batteries are installed correctly.
NOTE: The performance of the solar lamp will vary with the time of year. It will last longer when it has
had a full day in the sun rather than a day in overcast weather.
WINTERTIME TIPS: For optimal performance, be sure to remove any snow or debris
accumulation from solar panel(s). A solar panel free of debris will charge the batteries much
more efficiently.
WARNING: Please keep out of reach of children. Do not dispose of the Li-Ion battery in the regular trash,
municipal waste stream or by fire as batteries may leak or explode. Do not open, short circuit, or mutilate
batteries as injury may occur. Preserve our environment by recycling Li-Ion batteries or disposing of them in
accordance with local, State and federal regulations. Do not mix old and new batteries.
page 4
Replacement Batteries and Bulbs are available at
www.gamasonic.com