Gateway Computer Monitor User manual

SETTING UP YOUR GATEWAY MONITOR
2 Plug in the monitor
To protect your monitor from power fluctuations,
use a surge protector.
2Plug in the monitor
To protect your monitor from power fluctuations,
use a surge protector.
1 Connect your monitor to your computer
Follow the instructions that came with your computer.
1Connect your monitor to your computer
Follow the instructions that came with your computer.
3 Turn on the monitor3Turn on the monitor
* Available at www.gateway.com © 2005 Gateway, Inc. All rights reserved. Gateway is a trademark or registered trademark of Gateway, Inc. in the U.S. and other countries. Product specifications subject to change without notice. Actual product may vary from image shown.
2 Connect the USB power cord to a
USB port on your computer.
1 Tilt the screen back, center the speaker bar below
the screen, then tighten the thumb screws.
3 Connect the speaker bar’s headphone and microphone
cables to your computer, then turn on the speaker.
Digital DVI
(optional*)
AnalogVGA
(supplied)
ConnectingYour Flat Panel LCD Speaker Bar*
GettingHelp
See your documentation
Refer to the documentation that came with your monitor
or go to gateway.com to get the online documentation.
Check Gateway Support
For frequently-asked questions, setup help, and
immediate information on common technical issues,
go to gateway.com
MAN FPD2085/2185 POSTER R2 12/05