GE DLSR483GEWW User manual

DLSR483GECC/WW – GE®Super 7.0 Cu. Ft. Capacity Gas Dryer
Specification Created 11/03
370145
GE Appliances
Dryer Dimensions (in inches)
Exhaust Options:
2-way via rear and bottom. Dryer is shipped exhausted to the rear. Alternate
exhausting knockouts are supplied.
Gas: An individual properly-grounded branch circuit, with a three-prong
grounding-type receptacle, protected by a 15 or 20 amp circuit breaker or a
time-delay fuse is required.
Gas Dryer Electric Rating: 120V, 60Hz, 6A
Gas (BTU/HR): 22,000. Factory-equipped for natural gas. Tested for LP gas.
LP gas supply requires a conversion kit. Check installation instructions for
correct kit and have a qualified gas technician install a conversion kit. See dryer
ducting information for proper installation.
Note: Dryer wall outlet must be located within 36" of service cord entry and
accessible when dryer is mounted in position.
Installation Information: For complete information, see installation instructions
packed with your dryer.
36 42
27
23-1/2
2-1/2
25-1/2*
Side View Rear View
8-1/2
28-1/4
23-1/2
11-1/2
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
For answers to your Monogram,
®GE Profile™or
GE®appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
R
Listed by
Underwriters
Laboratories

GE Appliances
DLSR483GECC/WW – GE®Super 7.0 Cu. Ft. Capacity Gas Dryer
For complete information, see installation instructions packed with your dryer.
Ducting Materials:
For best performance, this dryer should be vented with 4" diameter all rigid metal exhaust duct. If “all rigid metal”
duct cannot be used, then “flexible all metal” venting can be used, but it will reduce the maximum recommended
duct length.
Exhaust Length Calculation:
1. Determine the number of 90° turns needed for your installation. If you exhaust to the side or bottom of dryer,
add one turn.
2. The maximum length of 4" rigid (aluminum or galvanized) duct which can be tolerated is shown in the table.
The maximum length for flexible ducts are less than for rigid duct.
2. A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated as a 90° elbow.
A turn over 45° should be treated as a 90° elbow.
Exhausting the dryer to the outside is strongly recommended to prevent large amounts of moisture and lint
from being blown into the room. Gas dryers or any dryer located in a closet must be exhausted to the outside.
Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed house floor (crawl
space), or into an attic, since the accumulated lint could create a fire hazard or moisture could cause damage.
Never terminate the exhaust into a common duct or plenum with a kitchen exhaust, since the combination of
lint and grease could create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc. The wall cap
must also be located at least 12" above the ground or any other obstruction with the opening pointed down.
Other terminations, such as louvered wall boxes, are acceptable provided they are equivalent to a 4" opening
dampered wall cap.
For more information on venting kits and accessories, please call 1-800-GE CARES.
For answers to your Monogram,
®GE Profile™or
GE®appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
Dryer Exhausting Information – Use Metal Duct Only
Vertical and Horizontal Ducting
Special Installation Requirements
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
• The dryer MUST be exhausted to the outside.
• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0" either side
3" front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".
• Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of
open area equally distributed. If this closet contains both a washer and a dryer, doors must contain
a minimum of 120 sq. in. of open area equally distributed.
• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors.
• The installation must conform with the local codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.
Minimum Clearances other than Alcove or Closet Installation:
• Minimum clearances to combustible surfaces
0" both sides
3" rear
Specification Created 11/03
370145
090 ft. 60 ft. 55 ft. 45 ft.
160 ft. 45 ft. 40 ft. 30 ft.
7.0, 6.0 and 5.8 2 45 ft. 35 ft. 30 ft. 20 ft.
Capacity Models 3 35 ft. 25 ft. 20 ft. 15 ft.
all Electric Dryers 4 25 ft. 15 ft. 15 ft. 10 ft.
090 ft. 60 ft. 55 ft. 45 ft.
7.0, 6.0 and 5.8 1 60 ft. 45 ft. 40 ft. 30 ft.
Capacity Models 2 45 ft. 35 ft. 30 ft. 20 ft.
all Gas Dryers 3 35 ft. 25 ft. 20 ft. 15 ft.
0150 ft. 125 ft. 55 ft. 45 ft.
1135 ft. 115 ft. 52 ft. 42 ft.
DLSR483E/G 2125 ft. 105 ft. 49 ft. 39 ft.
3115 ft. 95 ft. 46 ft. 36 ft.
4105 ft. 85 ft. 43 ft. 33 ft.
595 ft. 75 ft. 40 ft. 30 ft.
Number
of
90°
Turns
Maximum Length of 4"
Dia. Rigid Metal Duct
Maximum Length of 4"
Dia. Flexible Metal Duct
Exhaust Hood Type Exhaust Hood Type
Domestic
Dryer Models
A
4" Opening
B
2-1/2"
Opening
A
4" Opening
B
2-1/2"
Opening
A
4
Best Performance
B
2-1/2
A

GE Appliances
Specification Created 11/03
370145
DLSR483GECC/WW – GE®Super 7.0 Cu. Ft. Capacity Gas Dryer
FABRICCARE
4HeatSettings
START
COTTONS
AUTOMATIC
MOREDRY
MOREDRY
LESSDRY
COOL
DOWN
OPTIMUMDRY
LESSDRY
DEWRINKLE
DAMPDRY
MIN
20
30 40 50
60
70
80
EASYCARE
TIMEDDRY
STARTCOTTONS
REG.HEAT
FLUFF
NOHEAT
DELICATES
LOWHEAT
EASYCARE
MED.HEAT
AUTOMATIC
WRINKLEFREE
PERM.PRESS
DELICATES
5
C
l
o
t
h
e
s
C
a
r
e
C
y
c
l
e
s
-
S
u
p
e
r
C
a
p
a
c
i
t
y
E
n
d
o
f
C
y
c
l
e
S
i
g
n
a
l
Features and Benefits
• Long Vent – Delivers exceptional drying performance with duct runs of up to 150 ft.* for
greater installation flexibility (* of equivalent ducting)
• Auto Dry – Uses thermostats to monitor air temperature and reduce fabric wear
• DuraDrum™– Provides long-lasting dependability and durability
• Four heat selections – Provide the right temperature for the right drying results
• Wrinkle Care Extended Tumble – Continues to tumble clothes without heat to help prevent
wrinkling and creasing
• Interior Dryer Light – Lets you see everything inside for easy loading and unloading
• Eight dry cycles – A variety of fast flexible options for drying clothes
• Model DLSR483EEWW – White on white (Electric)
• Model DLSR483EECC – Bisque on bisque (Electric)
• Model DLSR483GEWW – White on white (Gas)
• Model DLSR483GECC – Bisque on bisque (Gas)