GE ZPBS360 User manual

BEFORE YOU BEGIN
Read these instructions completely and carefully.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions with
your Owner’s Manual for future reference.
Installation
Instructions
ACCE ORY PANEL KIT
ZP 360 – tainless teel
ZPB 360 – Black Acrylic
Kit Contents
• 2 Filler panels
(with PSS360 only)
• Door panel
• Grille panel
Tools Required
• Phillips screwdriver
• Safety glasses
• Gloves to protect against
sharp edges
• Wood block
• Hammer
REMOVE HANDLE AND TRIM
• Open the door to 90°. Remove the 6 Phillips head
screws from the door handle.
• Remove handle. Retain all screws.
• Remove 6 screws holding trim. Lift off trim.
Retain screws.
TEP 1 IN TALL PANEL
• Remove protective film from appearance panel.
• Slide panel into the door trim.
• If installing stainless steel panels, first slide filler
panel into the door trim, then slide stainless panel
into the trim.
• If necessary, tap with a wood block until panel slips
under the hinge side trim.
• There are two sets of holes in the handle side trim.
Replace side trim by installing the original screws
in the FRONT screw holes.
• Secure the handle to the door using the REAR
screw holes.
TEP 2
Use Rear Holes
to Secure Handle
Use Front Holes
to Secure Trim

IN TALL GRILLE PANEL
• Remove the protective film from the appearance panel.
• Raise the grille panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal backer panel and into
the trim.
• If installing Stainless steel panels, first slide the filler panel
into the trim, then slide the stainless panel into the trim.
• If necessary, tap with a wood block until the panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
TEP 3
31-46149
224D1889P009
06-08 JR
Note: Product improvement is a continuing endeavor at General Electric.
Therefore, materials, appearance and specifications are subject to change
without notice.
GE Consumer & Industrial
Appliances
General Electric Company
Louisville, KY 40225
ge.com
Loosen
Side
Trim
Screw
Loosen
Side
Trim
Screw
Adjust Nut Below
Spring to Accommodate
Panel Weight