GE ZPSS360 User manual

BEFORE YOU BEGIN
Read these instructions completely and carefully.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions with
your Owner’s Manual for future reference.
Installation
Instructions
ACCE ORY PANEL KIT
ZP 360 – tainless teel
ZPB 360 – Black Acrylic
Kit Contents
• 2 Filler panels
(with PSS360 only)
• Door panel
• Grille panel
Tools Required
• Phillips screwdriver
• Safety glasses
• Gloves to protect against
sharp edges
• Wood block
• Hammer
REMOVE HANDLE AND TRIM
• Open the door to 90°. Remove the 6 Phillips head
screws from the door handle.
• Remove handle. Retain all screws.
• Remove 6 screws holding trim. Lift off trim.
Retain screws.
TEP 1 IN TALL PANEL
• Remove protective film from appearance panel.
• Slide panel into the door trim.
• If installing stainless steel panels, first slide filler
panel into the door trim, then slide stainless panel
into the trim.
• If necessary, tap with a wood block until panel slips
under the hinge side trim.
• There are two sets of holes in the handle side trim.
Replace side trim by installing the original screws
in the FRONT screw holes.
• Secure the handle to the door using the REAR
screw holes.
TEP 2
Use Rear Holes
to Secure Handle
Use Front Holes
to Secure Trim
All manuals and user guides at all-guides.com
all-guides.com

IN TALL GRILLE PANEL
• Remove the protective film from the appearance panel.
• Raise the grille panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal backer panel and into
the trim.
• If installing Stainless steel panels, first slide the filler panel
into the trim, then slide the stainless panel into the trim.
• If necessary, tap with a wood block until the panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
TEP 3
31-46149
224D1889P009
06-08 JR
Note: Product improvement is a continuing endeavor at General Electric.
Therefore, materials, appearance and specifications are subject to change
without notice.
GE Consumer & Industrial
Appliances
General Electric Company
Louisville, KY 40225
ge.com
Loosen
Side
Trim
Screw
Loosen
Side
Trim
Screw
Adjust Nut Below
Spring to Accommodate
Panel Weight
All manuals and user guides at all-guides.com