Gear4music Large 3 Tier Studio Desk User manual

SWS-175
Large 3 Tier Studio Desk by Gear4music, 8U
Assembly Guide

SWS-175 Page 1 of 9
1. Connect the two main feet to the cross bar, using the washers
and screws. (Allen Key Required)
Attach the EVA pads underneat the feet if required.

SWS-175 Page 2 of 9
2. Put the two main desk brackets on the main feet as pictured.
Tighten with allen key.
The height of these brackets is optional.

SWS-175 Page 3 of 9
3. Connect the main shelf cross bracket to the main desk brackets,
as shown in the above picture. Tighten the screws.

SWS-175 Page 4 of 9
4. Attach the keyboard shelf brackets, as pictured, tighten the screws.

SWS-175 Page 5 of 9
5. Attach the equpment rack to the top of the main feet as shown.
Tighten screws.

SWS-175 Page 6 of 9
6. Connect the top shelf bracket to the stand, as pictured.

SWS-175 Page 7 of 9
7. Mount the keyboard shelf on the brackets and tighten the screws.
A safety screw is already installed, you can remove this to allow the
shelf to extend further.

SWS-175 Page 8 of 9
8. Install the main shelf with the wooden screws.
You need to pre-drill holes for the screws.
Check curve of the shelf, as per picture.

SWS-175 Page 9 of 9
9.Attach the top shelf, as per the last step, you will need to pre-drill holes.
Check curve of the shelf, as per picture.