Gecko LT50 User manual

Location and use
The Insect Killer is best located away from human activity and
hung at a height of around 2.5 metres. It is recommended that
the appliance be used continuously when people and pets are
present. Ensure the unit is placed away from other light sources.
Keep away from the reach of small children or hang using the
attached hanging harness. Connect the plug to a suitable power
supply, corresponding to that of the appliance, 230VAC, 50/60Hz.
For hanging use, an extension cord may be necessary.
This appliance is weatherproof and can be left outdoors.
Insect disposal and general maintenance
Regular maintenance of your appliance will keep it safe and in proper working order.
Insect Killer,
1. Before cleaning and maintenance
When not in use or before cleaning, always disconnect the appliance from the mains supply.
2. Cleaning
Remove bottom tray by twisting sideways (Figure 2) and empty dead insects from the appliance. If
needed, use supplied cleaning brush. As the high voltage grid is a vertical design, it should require
minimal cleaning. Do not use metal objects or stick fingers through outer casing. Regularly clean the
outside of the appliance with a soft damp cloth and dry it with a dry towel. Do not immerse in water.
Do not use harsh solvents to clean the plastic.
3. Ventilation
Always allow adequate ventilation for the appliance. Failure to do so may result in overheating.
4. Damage check
Always check that the appliance is in good working condition and all guards are secure. Check the
power supply cord and plug regularly for damage.
5. Lamp Replacement
For best results, check the lamp’s UV output annually.
After sundown, switch your unit on. Place the included
UV Indicator Keytag in close proximity to the units
outer casing so the white centre is in direct line of
sight of the lamp. Hold in place for around 2 minutes.
If the lamp is still emitting UV to attract mosquitoes,
the keyring centre will change to purple.
If the keyring centre remains white, the lamp
should be replaced.
IMPORTANT: Before replacing lamp, unplug unit from mains
power and wait one minute.
1. Remove catcher tray from bottom of unit
2. Gently remove and replace the lamp using lamp LT5OG.
3. Reinsert catcher tray.
Lamp is OK
Replace Lamp