GeekTale LB-01 User manual

L-B01/B02

GeekTaleGeekTale
Product Description & Dimention 1
3
4
7
Product packaging
Installation instructions
How to use
8
9
Troubleshooting
FCC Warning
10Specifictionst

luminous strip
Product Description
1

Product Dimention
2

Product packaging
(Two screws are backup)
3

Installation instructions
Do not use a power drill for installation.
Install and test the lock with the door open
to avoid being locked out.
Check the Dimentions &Install the latch
4

Installation instructions
5

Installation instructions
battery cover
Please do not load the Lithium Batteries or Rechargeable Batteries.
6

How to use
You will be asked to scan your fingerprint 6 times.
Adding new fingerprint needs to scan the administrator's fingerprint to verify besides the first one added.
How to enable the passage mode?
Scan administrator's fingerprint, Press the button on the interior handle when the lock is unlocked.
scan the fingerprint which you want to delete
Long press the setting button on the interior handle for seconds until you hear the voice prompt"Please long press the setting button to initialize",
then remove your finger and long press the setting button until you hear the prompt again.
How to enable or disable silent mode?
How to check the battery level?
How to reset the lock?
How to disable the passage mode?
Press the button on the interior handle twice.
7

Q: Any fingerprint can unlock the lock.
Q: I can't find the model of lock on the app.
A: This fingerprint lock does not use an app to save fingerprints or operate. Fingerprints are stored locally.
A: The lock was reset/in the default resetting or adding administrator fingerprint unsuccessfully, please make sure the fingerprint was added
successfully after installing.
8