Geemarc Ringer595 U.L.E Instruction manual

12
QUICK USER GUIDE
!!! Please refer to our website: www.geemarc.com for an up
to date user guide, as there may be important updates and
changes you need to be aware of !!!
IMPORTANT SAFETY INSTRUCTIONS
When using your equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and
injury, including the following:
1.Do not place this product on unstable shelves, stands, tables
or other surfaces.
2.Do not use the motion extension ringer in the following areas
that may cause deformation, malfunction, or operational
failure:
zUnder direct sunlight.
zAreas exposed to grease or steam, such as kitchens.
zNear fire or heating devices.
zAreas subject to extreme temperature changes, such as next
to air conditioners.
zAreas with IR-opaque or reflective objects that can block IR
energy that are needed for detection.
zAreas where the temperature is affected by strong illuminating
objects (such as halogen lights).
SAVE THESE INSTRUCTIONS
WHAT’S IN THE BOX
Your product package contains the following items. Save your
sales receipt and original packaging in the event warranty
service is necessary.
EXTENSION RINGER OVERVIEW
1. Flash LED (white)
zFlashes when receiving an incoming call, or when the
registered devices are triggered.
2. Loud speaker
3. LED indicators ( )
zGreen when the extension ringer is powered on.
zRed when the battery is low.
zAmber while checking signal strength.
4. Side switch Keys
_ Slide to switch between the ringer volumes
(low, medium, or high).
_Slide to switch between the alert modes
(flash only ( ), melody only ( ),
flash & melody ( ), or all off ( )).
_ Slide to switch between three doorbell melodies.
5. PAIR button ( )
zPress and hold for 5 seconds to enter the pairing mode.
6. Power jack
BEFORE USE
Batteries installation (purchased separately)
1. Push downward to remove the battery compartment cover
at the back.
2. Install three AA batteries into the battery compartment,
matching the polarity markings (+ and -) inside the battery
compartment.
Power on the extension ringer
Plug the small end of the power adapter to the power jack on
the extension ringer, and the large end to the wall jack.
Extension
Ringer Power adaptor

34
ADD AND REGISTER A EXTENSION RINGER
Add your new Ringer595 U.L.E extension ringer to your
telephone base. You only need to register if this is an
additional ringer that is seperate to the ringer included in your
pack. Your new extension ringer must be registered with the
AMPLIDECTTM595 U.L.E telephone base before use.
Register the extension ringer:
1. Make sure the extension ringer is powered on with batteries
or DC power before registering it to the telephone base.
2. Press and hold hanset locator key on the telephone
base until it starts to beep.
3. Press and hold the pair button (5) on the side of
the extension ringer until the Green Flash LED (3)
light flashes.
4. You will hear confirmation beeps when the extension ringer
is successfully registered to the base.
Replacing a extension ringer:
If you have purchased this new Ringer595 U.L.E accessory
extension ringer to replace an old extension ringer, you must
deregister the registered extension ringer first, and then
register this new extension ringer to your AMPLIDECTTM595
U.L.E telephone base.
GENERAL PRODUCT CARE
Taking care of your extension ringer
Your extension ringer contains sophisticated electronic and
optical parts, so it must be treated with care.
Avoid rough treatment
Place the extension ringer down gently. Save the original
packing materials to protect your extension ringer if you ever
need to ship it.
Avoid water
Your extension ringer can be damaged if it gets wet. Do not use
the extension ringer outdoors in the rain, or handle it with wet
hands. Do not install the extension ringer near a sink, bathtub
or shower.
Electrical storms
Electrical storms can sometimes cause power surges harmful
to electronic equipment. For your own safety, take caution
when using electrical appliances during storms.
Cleaning your extension ringer
Your extension ringer has a durable plastic casing that should
remain in good condition for many years. Clean it only with a
dry non-abrasive cloth. Do not use a dampened cloth or
cleaning solvents of any kind.
STORAGE
When you are not going to use the extension ringer for some
time, remove the battery from the extension ringer. Store the
extension ringer in a cool and dry place.
TROUBLESHOOTING
Below are the questions most frequently asked about the
extension ringer.
Problem Solutions
The extension
ringer doesn’t
work with the
telephone
system
equipment.
• Make sure the unit is connected to the power
supply, or with the AA alkaline batteries
installed.
• The extension ringer may be deregistered
from your telephone system. Refer to
Add and register a extension ringer and
register the extension ringer back.
• The extension ringer may be out of range.
Move the extension ringer closer to your
telephone system.
• If the previous suggestions do not work,
deregister all devices and register them to
the tele
p
hone base a
g
ain.
TECHNICAL SPECIFICATIONS
Frequency control Cr
y
stal controlled PLL s
y
nthesize
r
Transmit frequency 1881.792 MHz - 1897.344 MHz
Channels 10
Nominal effective
range Actual operating range may vary
according to environment conditions at
the time of use
RF powe
r
< 250mW
Power adaptor Input: 100-240V~ 50/60Hz 0.15A Output:
DC6V 0.45A, 2.7W adapte
r
Power requirements 3 x AA Alkaline batter
y
GUARANTEE
From the moment your Geemarc Ringer595 U.L.E is purchased,
Geemarc guarantee is for the period of two years. During this time,
all repairs or replacements (at our discretion) are free of charge.
Should you experience a problem then contact our help line or visit
our website at www.geemarc.com.
The guarantee does not cover accidents, negligence or breakages
to any parts.The product must not be tampered with or taken apart
by anyone who is not an authorized Geemarc representative.
The Geemarc guarantee in no way limits your legal rights.
IMPORTANT: YOUR RECEIPT IS PART OF YOUR GUARANTEE
AND MUST BE RETAINED AND PRODUCED IN THE EVENT
OF A WARRANTY CLAIM.
Please note: The guarantee applies to the United Kingdom only.
DECLARATIONS:
CE Directives
Geemarc Telecom SAhereby declares that this Ringer595 U.L.E
is in compliance with the essential requirements and other relevant
provisions of the RED 2014/53/UE.
The CE declaration of conformity may be consulted at
www.geemarc.com
Recycling Directives
The WEEE (Waste Electrical and Electronic Equipment) has been
put in place for the products at the end of their useful life are
recycled in the best way.
When this product is finished with, please do not put it in your
domestic waste bin. Please use one of the following disposal
options:
- Remove the batteries and deposit them in an appropriate
WEEE skip.
Deposit the product in an appropriate WEEE skip.
- Or, hand the old product to the retailer. If you purchase a new
one, they should accept it.
If you respect these instructions you ensure human health
and environmental protection.
For product support and help visit our website at www.geemarc.com
2 rue Galilée, 59791 GRANDE-SYNTHE CEDEX, FRANCE
telephone 01707 387602
lines are open 09h00 to 16h00 Mon to Fri
This product is made in China To Geemarc Telecom
QUGRINGER595 U.L.E_En_A4_V1.1
Other Geemarc Telephone Accessories manuals
Popular Telephone Accessories manuals by other brands

DynaMetric
DynaMetric TLP-124HS instruction manual

Lucent Technologies
Lucent Technologies INDeX 20DS Turret quick guide

Catalyst
Catalyst Total Protection Series instructions

Takeway
Takeway T-PH02 user guide

SSS Siedle
SSS Siedle ZT 711-01/12 Product information

CARETAKER SENTRY
CARETAKER SENTRY 41915 Setup instructions

ADDCOM
ADDCOM ADD-699 user manual

V-tech
V-tech DS6151 - 6.0 Expandable Cordless Phone user manual

Premier Technology
Premier Technology Hybrid 7600 Series Quick start manual

Zoom
Zoom Model 24 Installation and user guide

Amanda
Amanda [email protected]/Windows user guide

SSS Siedle
SSS Siedle Siedle Steel SBTLM 650-04 Product information