Gefen DVI-1000ST User manual

DVI•1000ST
Extender
USER MANUAL
www.gefen.com

Technical Support:
Telephone [phone]
[phone]
Fax [phone]
Technical Support Hours:
9:00 AM to 5:00 PM Monday through Friday.
Write To:
Gefen Inc.
C/O Customer Service
6265 Variel Ave.
Woodland Hills, CA91367-9897
Notice
Gefen Inc. reserves the right to make changes in the hardware, packaging and any
accompanying documentation without prior written notice.
The DVI 1000 ST is a trademark of Gefen Inc.
© 2005 Gefen Inc., All Rights Reserved
ASKING FOR ASSISTANCE

TABLE OF CONTENTS
Introduction
DVI 1000 STS Panel Descriptions
DVI 1000 STR Panel Descriptions
How To Connect The DVI 1000 ST
DVI 1000 ST Wiring Diagram
CAT5 Link Cable Wiring Diagram
Specifications
Warranty
1
2
3
4
5
6
7
8

READ THESE NOTES BEFORE INSTALLING
OR OPERATING THE DVI 1000 ST
• The fiber optics cable must be treated carefully when connectors are exposed. They
are susceptible to dust which can contribute to loss of pixels.
• The DVI 1000 ST works for all DVI displays and supports resolutions up to 1920x1200
• The DVI 1000 ST is housed in a metal box for better RF shielding.
• Supports DDWG standard for DVI compliant monitors
• Uses CAT-5 cable for HDCP/DDC and control signals.
OPERATION NOTES

INTRODUCTION
Thank you for purchasing Gefen’ s ex•tend•it DVI 1000 ST. The DVI 1000 ST allows ex-
tension of DVI up to 1640 feet without losing any quality.
CONTENTS
The DVI 1000 ST consists of:
--- (1) DVI 1000 STS
--- (1) DVI 1000 STR
--- (1) DVI cable (6FT)
--- (1) 12VDC Power Supply
--- (1) User's Manual
1

12 VDC
DVI 1000 STS (Front View Only)
DVI In
HDCP &
DDC Signals
BlueGreen
Red
Clock
Link Indicator
DVI 1000STS PANEL DESCRIPTIONS
DVI 1000 STS (Rear View Only)
Power LED indicates the unit is powered
2

12 VDC
DVI 1000 STR (Front View Only)
DVI Out
HDCP &
DDC Signals
Blue Green
Red Clock
Link Indicator
DVI 1000STR PANEL DESCRIPTIONS
DVI 1000 STR (Rear View Only)
Power LED indicates the unit is powered
3

Connect the DVI 1000 ST sender unit to the DVI source using the supplied cables.
Connect the DVI 1000 ST receiver unit to your DVI display.
Connect the four fiber optics and one CAT5 cable between the sender and receiver.
Plug the 12VDC power supplies into the DVI 1000 ST receiver.
You should see a beautiful picture.
* Cable Requirement - 50 or 62.5 micron multimode fiber optics cable
HOW TO CONNECT THE DVI 1000 ST
1
2
3
4
5
4

DVI 1000 ST WIRING DIAGRAM
5

CAT5 LINK CABLE - WIRING DIAGRAM
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
RJ-45 Jack RJ-45 Jack
2 3 4 5
6
7 8 1
2 3 4 5
6
7 8
1
1818
6