Gefen EXT-DVI-ELR User manual

®
DVI Extra Long Range
Extender
EXT-DVI-ELR
User Manual
www.gefen.com

ASKING FOR ASSISTANCE
Rev A3
Technical Support:
Telephone [phone]
[phone]
Fax [phone]
Technical Support Hours:
8:00 AM to 5:00 PM Monday through Friday, Pacic Time
Write To:
Gefen LLC
c/o Customer Service
20600 Nordhoff St
Chatsworth, CA 91311
www.gefen.com
[email protected]
Notice
Gefen LLC reserves the right to make changes in the hardware, packaging and
any accompanying documentation without prior written notice.
DVI Extra Long Range Extender is a trademark of Gefen, LLC
© 2013 Gefen LLC, All Rights Reserved.
All trademarks are the property of their respective owners.

CONTENTS
1 Introduction
2 Operation Notes
3 Features
4 Sender Unit Layout
5 Sender Unit Descriptions
6 Receiver Unit Layout
7 Receiver Unit Descriptions
8 Connecting the DVI Extra Long Range Extender
9 DIP Switch Conguration
12 Network Cable Wiring Diagram
13 Specications
14 Warranty

1
Congratulations on your purchase of the Gefen DVI Extra Long Range Extender.
Your complete satisfaction is very important to us.
Gefen
Gefen delivers innovative, progressive computer and electronics add-on solutions
that harness integration, extension, distribution and conversion technologies.
Gefen’s reliable, plug-and-play products supplement cross-platform computer
systems, professional audio/video environments and HDTV systems of all sizes
with hard-working solutions that are easy to install and simple to operate.
The Gefen DVI Extra Long Range Extender
The DVI Extra Long Range Extender over CAT-5 extends any DVI source to an
HD display or other digital signage application up to 330 feet (100 meters). This
product uses Gefen ELR technology, delivering uncompressed DVI video to
1920x1200 over a single CAT-5 cable, reducing cable costs and providing easier
installation.
How It Works
Place the DVI Extra Long Range Extender Sender Unit next to the DVI source.
Use the included DVI cable to connect the source to the Sender Unit. Connect
the Receiver Unit to the display with a DVI cable. Use one CAT-5 cable, up to
330 feet (100 meters), to connect the Sender to the Receiver Unit. Connect the
included locking power supplies to the Sender and Receiver Units, and then con-
nect both power cables to available electrical outlets.
INTRODUCTION

2
OPERATION NOTES
PLEASE READ THESE NOTES BEFORE INSTALLING OR
OPERATING THE DVI EXTRA LONG RANGE EXTENDER
• CAT-5 or CAT-6 cables should not exceed 330 feet (100 meters).
• Shielded (STP) CAT-5 or CAT-6 is recommended. However, un-shielded
(UTP) CAT-5 or CAT-6 is acceptable.
NOTE: The shielded cable has an advantage by providing immunity to
Electromagnetic Interference (EMI), cell phones and A/C motors.
• The Gefen DVI Extra Long Range Extender features the ability to generate
compatible EDID and Hot Plug signals when working with different brands of
source devices and monitors.

3
FEATURES
Features
• Supports DVI Resolutions to 1920x1200@60 Hz or 1080p at 330 feet (100
meters)
• EDID Management for Local and Pass-through modes
• Power save mode
• Digital signal transmission over CAT-5 cable for zero signal loss
• Locking Power Supplies for secure connections
• Wall mountable
Package Includes
(1) Gefen DVI Extra Long Range Extender - Sender Unit
(1) Gefen DVI Extra Long Range Extender - Receiver Unit
(1) 6 ft. DVI Cable (M-M)
(2) 5V DC Locking Power Supplies
(1) Quick-Start Guide

4
SENDER UNIT LAYOUT
Back
Front
2 3
1
4

5
SENDER UNIT DESCRIPTIONS
1 5 V DC Locking Power Connector
Connect the included 5 V DC locking power supply to this connector.
2 Power Indicator
This LED will turn bright blue once the included 5 V DC locking power supply
has been properly connected to the unit and the locking power supply has been
connected to an available electrical outlet.
3 DVI In
Connect a DVI cable from the computer to this DVI-I connector.
4 Link
Connects the Sender Unit to the Receiver Unit using CAT-5 / CAT-6 cable.

6
RECEIVER UNIT LAYOUT
Back
Front
3
4
21