Gefen Ext-dvikvm-lan-l User manual

Audio

Embedder

3GSDI

Release A2

User Manual

EXT-DVIKVM-LAN-L

DVI

KVM IP

Over

with Local DVI Output

DVI KVM over IP with Local DVI Output

Important Safety Instructions

GENERAL SAFETY INFORMATION

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this product near water.

6. Clean only with a dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s

instructions.

8. Do not install or place this product near any heat sources such as radiators, heat

registers, stoves, or other apparatus (including ampliers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized

plug has two blades with one wider than the other. A grounding type plug has two

blades and a third grounding prong. The wide blade or the third prong are provided for

your safety. If the provided plug does not t into your outlet, consult an electrician for

replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at plugs,

convenience receptacles, and the point where they exit from the apparatus.

11. Only use attachments/accessories specied by the manufacturer.

12. To reduce the risk of electric shock and/or damage to this product, never handle or

touch this unit or power cord if your hands are wet or damp. Do not expose this

product to rain or moisture.

13. Unplug this apparatus during lightning storms or when unused for long periods of time.

14. Refer all servicing to qualied service personnel. Servicing is required when the

apparatus has been damaged in any way, such as power-supply cord or plug is

damaged, liquid has been spilled or objects have fallen into the apparatus,

the apparatus has been exposed to rain or moisture, does not operate normally,

or has been dropped.

15. Batteries that may be included with this product and/or accessories should never be

exposed to open ame or excessive heat. Always dispose of used batteries

according to the instructions.

DVI KVM over IP with Local DVI Output

Warranty Information

Gefen warrants the equipment it manufactures to be free from defects in material and

workmanship.

If equipment fails because of such defects and Gefen is notied within two (2) years from

the date of shipment, Gefen will, at its option, repair or replace the equipment, provided

that the equipment has not been subjected to mechanical, electrical, or other abuse or

modications. Equipment that fails under conditions other than those covered will be

repaired at the current price of parts and labor in effect at the time of repair. Such repairs

are warranted for ninety (90) days from the day of reshipment to the Buyer.

This warranty is in lieu of all other warranties expressed or implied, including without

limitation, any implied warranty or merchantability or tness for any particular purpose, all of

which are expressly disclaimed.

1. Proof of sale may be required in order to claim warranty.

2. Customers outside the US are responsible for shipping charges to and from Gefen.

3. Copper cables are limited to a 30 day warranty and cables must be in their original

condition.

The information in this manual has been carefully checked and is believed to be accurate.

However, Gefen assumes no responsibility for any inaccuracies that may be contained

in this manual. In no event will Gefen be liable for direct, indirect, special, incidental, or

consequential damages resulting from any defect or omission in this manual, even if

advised of the possibility of such damages. The technical information contained herein

regarding the features and specications is subject to change without notice.

For the latest warranty coverage information, refer to the Warranty and Return Policy under

the Support section of the Gefen Web site at www.gefen.com.

PRODUCT REGISTRATION

Please register your product online by visiting the Register Product page under the

Support section of the Gefen Web site.

iii

DVI KVM over IP with Local DVI Output

Gefen, LLC

c/o Customer Service

20600 Nordhoff St.

Chatsworth, CA 91311

Telephone: (818) 772-9100

(800) 545-6900

Fax: (818) 772-9120

Email: [email protected]

Visit us on the Web: www.gefen.com

Technical Support Hours: 8:00 AM to 5:00 PM Monday - Friday, Pacic Time

DVI KVM over IP with Local DVI Output is a trademark of Gefen, LLC.

Important Notice

Gefen, LLC reserves the right to make changes in the hardware, packaging, and any

accompanying documentation without prior written notice.

All trademarks are the property of their respective owners.

Contacting Gefen Technical Support

DVI KVM over IP with Local DVI Output

• Always make sure that the DVI KVM over IP with Local DVI Output is running the

latest version of rmware. Go to the Support section of the Gefen Web site to

download the latest version of rmware. See Upgrading the Firmware for instruction

on performing the upgrade procedure.

• The DVI KVM over IP with Local DVI Output is compatible with the HD KVM over IP

and the VGA KVM over IP, allowing any combination of HDMI, DVI, and VGA Senders

and Receivers to be used in a single system. Note: When using HDCP-encrypted

content, only HDMI Senders and Receiver units can accept and display the content.

• CAT-5 or CAT-6 cables should not exceed 330 feet (100 meters) between the

Sender / Receiver unit and the network.

• By default, all Sender and Receiver units are set to channel 0.

• This product does not support HDCP or dual link resolutions.

• By default, the source device will use the EDID from the display (or other sink device)

which is connected the Receiver unit. See EDID Management for more information.

• If terminating network cables in the eld, please adhere to the TIA/EIA568B

specication. See the Network Cable Diagram for details.

The following table (continued on next page) details the IP and IP port use of the DVI KVM

over IP with Local DVI Output. Each “X” in the table, below, represents that no specied IP

port is required.

Type Sender A D Receiver Description

Link Manager

TCP 6751 A X msg_channel, ast_heartbeat

UDP / MC X D3246 ast_heartbeat multicast port

Use the “multicast stream” multicast IP

UDP / MC 3333 D 3334

3334 A 3333

“Name Service”

Use 225.1.0.0 multicast IP

3333 listen for query; 3334 for reply

Operating Notes

IMPORTANT: The use of a Gigabit switch with 8K “jumbo frame”

capability is required when connecting the DVI KVM over IP with

Local DVI Output to a network.

Operating Notes

Type Sender A D Receiver Description

Video over IP

UDP / MC 3344 A Xcontrol channel

TCP 3344 A Xcontrol channel

TCP 3240 A XTCP unicast mode only

UDP X D 3245 UDP unicast mode only

(unicast mode default mode uses

UDP, not TCP)

UDP / MC X D 3245 multicast mode only

Type Sender A D Receiver Description

I2S over IP

TCP 1234 A Xcontrol channel

UDP / MC X D 1235 data streaming for both unicast and

multicast mode

Type Sender A D Receiver Description

USB over IP

TCP 6000 A XUSB over IP data

TCP 6755 A Xvhub_heartbeat

USB over IP-specic

Type Sender A D Receiver Description

Serial over IP

TCP X D 6752 type 1

TCP 6752 A Xtype 2

Type Sender A D Receiver Description

IR over IP

TCP 18771 A Xupstream IR over IP data

UDP / MC X D 18770 downstream IR over IP data

TCP 18770 A XIR over IP data

(TCP unicast mode only)

DVI KVM over IP with Local DVI Output

vii

Features

• Extends DVI, USB, RS-232, and stereo analog audio over IP, using a Gigabit Local

Area Network.

• Any combination of HDMI, DVI, and VGA Senders and Receivers can be used

together to create a “Virtual Matrix”

• Senders and Receivers can be used together to create a “Virtual Matrix”

• Supports resolutions up to 1080p Full HD and 1920 x 1200 (WUXGA)

• Supports a local DVI monitor at Sender side

• Supports 4 USB devices at Receiver side, with 500mA current capability per port,

USB 2.0 data rates up to 480 Mbps, and backward-compatibility with USB 1.1

• Supports 256 Senders and a total of just over 65,000 Receiver units, depending on

the network bandwidth and number of ports of your network switch

• Three-port Ethernet switch built into the Receiver unit

• +/USB and -/Select buttons on Receiver unit allow selection of multiple Senders

• +/USB button on Receiver unit allows multiple Receivers to access a USB host

computer

• Mode button on Sender for sharpness or motion optimization of image

• Easy-to-use web server interface for quick system set-up and rmware upgrade

• Locking power supply connectors

• 1U tall, half-rack width enclosures are rack-mountable using EXT-RACK-1U

• Surface mounting brackets included

Packing List

The DVI KVM over IP with Local DVI Output ships with the items listed below. If any of

these items are not present in the box when you rst open it, immediately contact your

dealer or Gefen.

• 1 x DVI KVM over IP w/ Local DVI Output - Sender Unit

• 1 x DVI KVM over IP - Receiver Unit

• 1 x Dual Link DVI Cable

• 1 x 6 ft. USB Cable

• 1 x 6 ft. DB-9 Cable

• 2 x L-Shaped Mounting Brackets with screws

• 1 x 5V DC Power Supply - for Sender

• 1 x 5V DC Power Supply - for Receiver

• 1 x AC Power Cord

• 1 x Quick-Start Guide

Features and Packing List

1080P

DVI KVM over IP with Local DVI Output

3GSDI Audio Embedder

DVI KVM over IP with Local DVI Output

Table of Contents

viii

01 Getting Started

Sender Unit Layout................................................................................................ 2

Front.............................................................................................................. 2

Back .............................................................................................................. 3

Receiver Unit Layout............................................................................................. 4

Front.............................................................................................................. 4

Back .............................................................................................................. 5

Installation ............................................................................................................. 6

Using a Direct Connection ............................................................................ 6

Local Area Network (LAN) Connection ......................................................... 8

Supplementary Connections ....................................................................... 10

Sample Wiring Diagram .............................................................................. 11

02 Operating the

DVI KVM over IP with Local DVI Output

Basic Operation................................................................................................... 14

Displaying the IP Address and Video Channel ........................................... 14

Setting the IP Mode..................................................................................... 16

Setting the Video Channel .......................................................................... 17

Enabling or Disabling Video over IP............................................................ 19

Unicast and Multicast Modes .............................................................................. 20

Conguring Unicast Mode........................................................................... 20

Switching between Sender units in Unicast mode ...................................... 22

Conguring Multicast Mode......................................................................... 25

Using RS-232...................................................................................................... 27

RS-232 under Unicast Mode....................................................................... 29

RS-232 under Multicast Mode..................................................................... 29

USB Control ........................................................................................................ 30

USB under Unicast Mode............................................................................ 30

USB under Multicast Mode ......................................................................... 32

EDID Management.............................................................................................. 36

Using the Internal DVI EDID ....................................................................... 36

Using the Downstream EDID ...................................................................... 37

Audio Connections .............................................................................................. 38

Using HDMI Sources................................................................................... 40

Setting the Video Mode....................................................................................... 41

Performing a Factory Reset ................................................................................ 42

Sender Unit ................................................................................................. 42

Receiver Unit............................................................................................... 42

DVI KVM over IP with Local DVI Output

Table of Contents

03 Appendix

Upgrading the Firmware...................................................................................... 46

Developer Notes.................................................................................................. 48

Network Cable Diagram ...................................................................................... 49

Rack Tray Installation .......................................................................................... 50

Specications ...................................................................................................... 51