3. The condition of the chain and sprocket are important for drive package's useful life. Remember to
regularly it lubricate each link of the chain with chain oil –a drop on each link is a good rule of thumb.
Note also that the chain and sprocket are wear components that must be replaced occasionally.
4. In case of replacement of wear components such as chain, gears, cables, housings, brake pads,
tires, tubes, if need, please contact the shop.
6. Make it a habit to regularly check that brakes and gears are properly adjusted.
7. Remember to always keep your tires properly inflated to protect the wheels and make cycling safer. For
dry and even road conditions, you can fill the tires up to maximum
minimum recommended pressure. In muddy and uneven basis, you should not fill the tires to more than
just a recommended minimum pressure. Recommended pressure found on its deck.
8. Use lights and reflector when riding in the dark.
9. Always wear an approved bicycle helmet when cycling.
10. A properly adjusted seat is of great importance for cycling experience. Therefore, make sure to
adjust the seat height to suit your needs. Once a year, should also seatpost and stem cleaned and
lubricated for the parts not to get caught. Bicycle recommended Fat greasing.
11. The battery should be stored indoors when not in use. Make it a habit to take the battery out after
completion Mountain biking.
12. Avoid water coming in contact with the bike's electrical parts. Ride with the electric bike
Functionality
Electrical bike has low voltage which means that the power supply is automatically stopped when the
voltage of the battery becomes insufficient.
The power supply is automatically stopped when the speed exceeding 25 km / h.
The power supply will stop automatically immediately after you stop stepping on the pedals. The torque
sensor saves much power.
When riding on muddy or rutted roads, you should ride without auxiliary motor. Dirt and mud can cause
worse force or the sensor is damaged.
Use both hand and foot brake together. When handbrake pressed stop the auxiliary engine. Take
therefore habit to slow down with both hand and foot brake simultaneously.
Children and elder may not be mounted on electrical bike.
Start electrical bike
The bike comes with the battery in standby mode. This must be disabled before the first charge (about 4-6
hours) can be performed. Keep the battery indicator button for 2 seconds. The LEDs blink until the battery
is enabled. This standby function is automatically activated when the battery. Ministry not been used for 24
hours.
To activate the standby mode manually, the indicator. Keep the button pressed for 2 seconds. A simple
pushing on the indicator button shows the battery charge level.
