Gemini 2700 User manual

INSTALLATION
INSTRUCTIONS
2700 - Gemini
Mechanical
lowe-and-fletcher.co.uk
Installation Template
Please check that template is
correct size before use –
copies can be distorted
is there a template for this
product?
Lowe & Fletcher Ltd
Moorcroft Drive
Wednesbury, West Midlands
WS10 7DE, England
T: + 44 (0) 121 505 0400
F: + 44 (0) 121 505 0420
E: [e-mail]
W: www.lowe-and-fletcher.co.uk
Cut Here
9224236 V1 July 2017 - 2700 Installation Instructions
(9)
(71)
88
28
(10.5)
(10.5)
R2.5 MAX.
(4 x CORNERS)
(
14.5)
(
4.5)
(
4.5)
IMPORTANT NOTE
For ush t option, use rectangular aperture (88mm x 28mm)
For surface mount option, use 3 x hole positions

INSTALLATION INSTRUCTIONS
2700 - Gemini Mechanical
The 2700 lock can be installed in two ways:
- Surface Mount (accessory kit 951700_)
- Flush Mount (accessory kit 951600_)
Surface Mount
Step 1 Remove all packaging.
Step 2 Fit the surface mount sleeve to lock as shown in Picture 1.
Step 3 Position the lock on the outside of the door as shown in Picture 2.
Step 4 Holding the lock in position, t the 2 x M4 pan head screws
(supplied with the surface mount sleeve) as shown in Picture 3.
Step 5 Tighten the 2 x M4 screws using a No.2 Posidriv® to 1Nm.
Step 6 Position the cam onto the rear of the lock as required, t the cam
washer and xing screw as shown in Picture 6.
Step 7 Tighten the cam xing screw using a No.2 Posidriv® to 1.5Nm.
Take care not to damage the screw thread when tting the screw.
Step 8 Before closing the door, test the lock by selecting the correct
User Code and rotating 90°.
Step 9 Your lock should now be ready to use.
Flush Mount
Step 1 Remove all packaging.
Step 2 Position the lock on the outside of the door as shown in Picture 4.
Step 3 Holding the lock in position, t the clamp box and 2 x M4 pan head
screws (supplied with the clamp box) as shown in Picture 5.
Step 4 Tighten the 2 x M4 screws using a No.2 Posidriv® to 1Nm.
Step 5 Position the cam onto the rear of the lock as required, t the cam
washer and xing screw as shown in Picture 6.
Step 6 Tighten the cam xing screw using a No.2 Posidriv® to 1.5Nm.
Take care not to damage the screw thread when tting the screw.
Step 7 Before closing the door, test the lock by selecting the correct
User Code and rotating 90°.
Step 8 Your lock should now be ready to use.
Picture 1.
Fit surface mount sleeve to lock as shown.
Picture 4.
Position lock through door panel as shown.
Picture 2.
Position lock on door panel as shown.
Picture 5.
Fit clamp box and 2 x M4 pan head screws as shown.
Picture 3.
Fit 2 x M4 pan head screws as shown.
Picture 6.
Fit cam, washer & screw. Tighten with No.2 Posidriv®.