Gemini GE370 User manual

GE370 –GEMINI ELECTRONIC:
BASIC PROGRAMMING STEPS
Changing the master code:
Out of the box, the GE370 is already programmed with a default master code
(11 33 55 77) and a default user code (22 44). It is highly recommended by the
manufacturer that both of these codes be changed immediately by the user
after installation. Do NOT forget the new master code you choose –you will
not be able to use any of the programming functions without the master code.
***Make sure the lock is unlocked prior to any programming***
To change the master code, follow these steps: (1) Press “#” [there will be two
quick green flashes] (2) Enter the old master code [you will see several rapid
green flashes] (3) Press “01”[you will see several rapid green flashes] (4) Enter
your new 8 digit master code [you will see several rapid green flashes] (5) Re-
enter your new 8 digit master code to confirm. Your new master code is set.

Changing the user code:
“Public” and “Private” modes:
Changing to “Private” mode:
To change the user code, follow these steps: (1) Press “#” [there will be two
quick green flashes] (2) Enter the master code [you will see several rapid green
flashes] (3) Press “02”[you will see several rapid green flashes] (4) Enter your
new 4 digit user code [you will see several rapid green flashes] Your new user
code is set.
***Please note: when utilizing any of the programming functions on your
digital lock, you must start each new step within 3 seconds of the last step or
the process will “time-out”. This time-out will be shown by several rapid red
flashes***
The GE370 is set to “Public” mode by default, which means you must enter the
user code once to unlock and enter it two times consecutively to lock after
turning the knob back to the locked position. You can change your lock to
“Private” mode which allows automatic locking. Once the code is entered to
unlock in Private mode, you will see orange flashes for 3 seconds (as shown in
the image below) and the lock automatically locks regardless of what position
the knob is in. This eliminates the need to enter the code again to lock.
To change to “Private” mode, follow these steps: (1) Press “#” [there will be
two quick green flashes] (2) Enter the master code [you will see several rapid
green flashes] (3) Press “09” [you will see several rapid green flashes] (4) Enter
your new 4 digit user code. Private mode has been set.

Changing back to “Public” mode:
If you wish to change back to Public mode, repeat the steps for Private mode,
but on step (3) press “08”- step (4) will not apply when changing back to Public
mode. ***Please note: The user codes for Public/Private modes can be
different if you choose. If you change back to Public mode, the user code will
be what Public mode was originally programmed to.***
This is an overview of the basic programming functions on the GE370 digital
lock. For more advanced programming, please refer to the manufacturer
Operating and Programming Instructions that are included with your lock.