Genexis FiberTwist Series User manual

Bracket-
FiberTwist Series
Installation Guide

In the box
Bracket- front view Bracket- rear view
wall plugs & screws
Bracket- patch-in
rear view
or

Coniguration options
Bracket- Bracket- with patch cable Bracket- with patch-in
connector
Depending on the coniguration option the following steps can be
done:
. Bracket-: walk through all steps of this installation guide.
. Bracket- with patch cable: stat at the drill holes section of this
installation guide.
. Bracket- with patch-in connector: stat at the drill holes section of
this installation guide.

Installation guide
Choose coniguration
When your Bracket- has a pre-installed patch-cable or patch-in coupler,
you can skip the steps described below and continue to the drill holes
section. If not:
• Choose one of the three ingress pots to use for the feeder iber.
• If using ingress  or , please cut out the oblong on the Bracket-. If using
ingress , the oblong is already cut out by default.
• For a patch-in, cut out the rectangle at the botom of the Bracket-.
Ingress 
Ingress 
Ingress 
Patch-in

Atach patch cable
When a patch cable is already pre-installed
in the Bracket-, or when it has a patch-in
coniguration, you can skip the steps described
below and continue with 'Finish installation'.
If not:
• Remove the SCAPC coupler from the
Bracket-.
• Take the protective black cap o the top end
of the coupler and o the iber connector,
and plug the iber connector into the coupler.
• Put the coupler and iber back in the
Bracket-.
There is only one correct way to put the
connector back in the Bracket-:
• The slots must be facing downwards.
• The single metal clip on the let hand side
must face towards the let side.
Clip

Store overlenth of iber
Depending on which iber ingress pot was chosen, run the patch cord
through the iber management system in the appropriate fashion.
It is impotant to run the iber as shown below in order to avoid sharp
bends that will cause signal degradation.
To get some extra lenth of the cable when your patch cable is pre-
installed, you can remove one circle of the rolled iber. Typically this is
rolled up  circles.
Ingress point botom Ingress point side Ingress point top

Drill holes
Drill wo holes in the wall when needed, depending on wall suface. Inset
the plugs so that the Bracket- can be screwed to the wall.
Use the Bracket- to mark the location to drill holes, if needed a
drilling template is available on htps:genexis.euproductibewist
downloadsbracket
 mm

Finish installation
• Make sure all ibers are contained under the lips.
• Screw the Bracket- to the wall or on the wall junction box.
• Connect the loose end of the patch cable to your iber outlet.
• For the patch-in coniguration, connect a patch cable beween your iber
outlet and the patch-in connector.
• Remove the remaining protective cap from the FiberTwist coupler.
• Install the active unit as described in the installation guide of the active
FiberTwist product.

Genexis assumes no responsibiliy for any inaccuracies in this document. Genexis reseves
the right to change, modify, transfer, or othewise revise this publication without notice.
Revision . September , Copyright ©  Genexis Netherlands B.V. All rights reseved.