GenInterlock SYL-200 User manual

Model!
SYL-200 Pat. Pending
Main Breaker!
150 or 200 amp single handle Vertical throw down (off), up (on)
Spacing from lower part of main to first breaker 3 ¼”
Generator Breaker!
Top left side 2 positions
!
WARNING
Only qualified personnel should be working on the panel box
An amateur should NEVER open the panel box
Please follow all rules and regulations of the National Electric Code
Step 1: Disassemble the interlock. Place the bottom plate (holes only) parallel to the breaker on the left and the
side of the panel, as in the picture. And mark holes.
Step 2: Turn off main breaker and remove panel cover.
Step 3: Drill holes as marked on panel cover with supplied 3/16 drill bit and remove all burs from drilling cover.
Step 4: Insert screws from rear of cover, install bottom plate, and install top plate (slotted) with retaining nuts.
Ensure proper movement.
Step 5: Install 2 pole Generator breaker on top left side and place Generator Warning Sticker on Generator
breaker.

Step 6: Re-Install panel cover, Verify proper operation of interlock. Main breaker ON, generator breaker OFF
and generator breaker CAN NOT be turned on. Generator breaker ON, main breaker OFF and main
breaker CAN NOT be turned on.
Main On Generator On
Place Generator start-up procedure label on panel box, Place CAUTION label on panel box and electric meter
pan.
The MAIN and the GENERATOR breakers should NEVER be able to be turned on at the same time. If panel
cover is removed the Generator breaker is NEVER to be turned on. If for any reason the interlock does not
function properly, DO NOT USE and contact us immediately at [e-mail] for support and
instructions.
Thank You for your support,
GenInterlock Team
DISCLAIMER: GenInterlock.com is NOT responsible for misuse or improper
installation. All electrical equipment should be installed and maintained by
qualified personnel. Any consequences arising from improper use is the
responsibility of the user.
GenInterlock.com
2227 US Highway 1 – Unit 124
North Brunswick, NJ 08902
[email protected]
732-339-4191