FEATURES
Ø Support Power tuning;
Ø Transmit power 4 gear switch: 0mw/25mW/100mW/200mW;
Ø The output power is stable ,the far transmission distance: ≥0.6km@25mW, ≥1km@100mW, ≥
1.5km@200mW
Ø Output 48 frequency points, and has R group 8 race frequency at the same time using each other
without interference;
Ø Frequency lock fast, boot does not interfere with companions;
Ø Full format video format: NTSC /PAL;
Ø Wide input voltage range. low power consumption; 7V～24V, +12V/170mA@200mW;
Ø Small volume: 25mm×25mm×4.5mm;mounting holes 20mm×20mm(4 * M2) correspond exactly mini
CC3D NAZE32 F3 F4 Flying control
Ø Light weight: ≤3.5g(including antenna)
SPECS
1. Channel output : 48Ch(A,B,E,F,H,R)
2. Input voltage : 7-24V DC (2-6S)
3. Vtx output the camera voltage: 5v
4. Power transmission: 0mW / 25mW / 100mW / 200mW
5. Size (mm): 25 * 25 * 4.5
6. Mounting Holes Dimension:20*20mm
7. Connector type: IPEX Connector
8. Weight: 3.5g(including antenna)
How to use?
1
．
Set the Channel
In standby mode, press and hold the key for 3 seconds, the blue LED flashes, short press, change the channel
value.Every time 1 press will change the CH, followed by 1CH to 8CH cycles.
2
．
Set the Band
In the channel setting mode, press and hold the key for 3 seconds, the green LED flashes, briefly presses,
changes the frequency group value.Every time 1 press will change the band, and then the A band to F band
loop.
3. Set the Power
In the band setting mode, press and hold the key for 3 seconds, the red LED flashes, short press, change the
output power value.Every time 1 press will change the power, followed by 25mW / 100mW / 200mW cycle.
