GFI Kerio Control Box NG510 User manual

NG510/NG511 - QUICK START GUIDE
This document is a quick guide for safely installing and implementing Kerio Control Boxes NG510 and
NG511 UTM appliances.
1. General Safety Instructions
During installation follow these security instructions:
- The appliance should be placed on a flat surface or securely mounted horizontally in a rack
enclosure.
- The NG510/NG511 series are intended primarily for server rooms due to noisy performance.
- Do not attempt to open or disassemble the appliance for any reason.
- Strictly follow the installation instructions (see section 3).
- Do not place the appliance near a heat source.
- Place the appliance in a ventilated space, making sure that the appliance fans and vents are
unobstructed at all times.
- Do not expose the appliance to liquids of any kind.In the event of liquid intrusion,unplug the
appliance immediately.
- Verify that the voltage and frequency of the power socket matches the values printed on the
power adapter before plugging in the appliance. Use only the power adapter supplied with the
appliance.
- Do not place any items on top of the power cable; keep the power cable away from walkways or
other areas where it could pose a tripping hazard.
-
2. Appliance Description
Kerio Control Box NG510 —1U rack mountable appliance
Kerio Control Box NG511 —1U rack mountable appliance
Feature
Description
Serial port
Used for connecting to a console with a serial
cable
USB ports
Input for USB devices
Ethernet network ports
Used for connecting to the Internet and the LAN
with an Ethernet cable

Screenshot 1: Kerio Control Box NG510 (front)
Screenshot 2: Kerio Control Box NG511 (front)
3. Kerio Control Hardware Appliance Installation and Configuration
After you have set the appliance at a suitable place and plugged it into a power outlet according to
the safety instructions,it is time to connect it to the network and configure settings.
Screenshot 3: Connecting Kerio Control Box NG510 to the network

Screenshot 4: Connecting Kerio Control Box NG511 to the network
To configure the appliance:
1. Connect the Internet port to the Internet (e.g.DSL or Cable modem) using an Ethernet
cable.
2. Connect the LAN port to the computer that will be used to configure the appliance (see the figures
above).
3. Turn on the appliance.
Now you have two options:
- Add and manage the appliance through MyKerio. See
https://go.gfi.com/?pageid=ControlMyKerio .
- Access the Kerio Control Administration through a browser (see below):
1. Set the networking preferences for Ethernet on the connected computer to “Automatic DHCP
configuration”. (You can change it later after the configuration is complete).
2. Renew the DHCP lease on the computer and confirm it has an IP address of 10.10.10.11
3. Open a web browser and connect to the Kerio Control Administration web interface using the following
URL:
https://10.10.10.1/admin .
4. Ignore the SSL certificate warnings and proceed to the configuration wizard.
5. Follow the instructions provided by the wizard and configure the appliance.
See https://go.gfi.com/?pageid=ControlActivationWizard .
For troubleshooting purposes, you can use the serial port to connect the console to the appliance. See

https://go.gfi.com/?pageid=ControlSerial for details.
Additional Information
For further assistance with configuration refer to additional documentation in
https://go.gfi.com/?pageid=ControlManual .
For online support, resources visit https://support.gfi.com/ or https://forums.gfi.com for community based
support.