6
ENGLISH
USE METHOD
Feature
Tredelenburg & revese tredelenburg: 0-12 degree , adjusted by the gas spring.
Hi-Low: 650-900 mm ,adjustable height, easy for mother and baby to communicate in a suitable position.
Size: 875Lx525Wx(650-900)mm
grooves in the Chassis guard harbor the floor from baby’s wash.
The castors with brake and ones without are assembled oppositely,which is more stable and reliable .
Don’t use the device in direct contact with the skin.
Use method
Put your palm on the lift holdand lift the switch with your fingers, then the cart will be up; while depress the cart
with the switch lifted, then the cart will be down.
Tredelenburg and reverse tredelenburg: raise or depress the rail by lifting tredelenburg swtich, then these functions
can be activated, while release the switch, it can be held at any angle within scope.
Brake : press the brake pedals for braking the cart.
FAULTS EXCLUSION
Common failures Probable reasons Excluding methods
Difcult to move the whole baby cradle 1. The caster is locked without
releasing the brake
2. The caster is damaged
1. Release the brake
2. Replace the caster
BABY CRADLE-MAINTENANCE
1. In order to use the baby cradle safely, it is necessary to perform regular safety inspections on the baby
cradle. It is recommended to check it every six months to ensure that the connections are not loose and all
operations are normal.
2. When the baby cradle frame ages and it reaches a certain servicing time, which the metal part of the baby
cradle and plastic parts of the baby cradle frame can be recycle.
3. Avoid scratching the panel with sharp-angle appliances or knives during use, and clean it frequently to keep
it clean and dry.
4. If the panel is accidentally stained with stains, it is recommended to clean it. Do not use alkaline or corrosive
chemicals to clean the baby cradle.
5. Regularly check the casters to avoid hitting or overloading, which will cause damage to the casters.
6. It is forbidden to force the casters to brake when braking, which will cause damage to the brake system.
7. The wear of the tire surface of the wheel can be detected by visual inspection. Some thread spun yarn and
other accumulations may be wrapped around the wheel, remove the bolts and nuts of the wheel, clean up
the debris, and check whether the bearing of the wheel is damaged. If the parts are not damaged, can be
reassembled and used.
8. Judging whether the caster is replaced according to the time used, wear and tear, you can replace the
wheels and make sure that the axles bolt and nuts are well put together and connected. If possible, use a
lock washers or locknuts to help you with this process.
9. For the casters equipped with brakes, it is necessary to regularly check whether the brakes are working
properly. Check the brakes once a day or before each use. For a baby cradle equipped with multiple brake
casters, only one brake caster can be locked at a time which will allow you to try and push the baby cradle
also check whether one of the brake performance of each caster is good. If the function of the brake fails due
to wear or damage to the wheels, immediately replace the wheels and then retest the brake system.
10. If the mechanism of the brake system of the caster is damaged, and the brake needs to be repaired or
replaced, please contact our after-sales service department or authorized dealer provide by our company.
Every time the brakes are replaced, the brake performance of the casters must be retested.
BABY CRADLE-CLEANING
1. When cleaning, please wring out the cloth soaked in neutral detergent diluted with water and wipe it, then
wring out the cloth soaked in water to wipe off the remaining detergent ingredients, and nally use a dry wipe
dry with a cloth.
2. Do not use volatile substances (thinner, volatile agent, gasoline, etc.), which may cause chemical reactions
and damage the Baby cradle.
3. When using a disinfectant to clean, be sure to dilute it according to its specied concentration before use.
