gizmosphere Gizmo User manual

Gizmo Explorer Board: This is a companion board for the Gizmo 2
platform. This IO expansion boards connects to the Gizmo 2 via
the low-speed connector, and provides access to motor control,
LCD display. Serial interface, GPIO and prototyping breadboard
area to help with development and customization for different
applications. Keypad is included with the Gizmo Explorer Board.
Setting Up the System
1. Connect the Explorer Board to the Gizmo 2 platform via the
low speed expansion connector as shown.
2. Connect the Keypad to the GPIO header as shown in the
setup.
3. Connect a USB keyboard, mouse to the Gizmo 2. Ensure the
SD card is plugged in.
4. Connect the power supply to the Gizmo 2 and power up the
board.
For more information on hardware, documentation and software please
visit www.gizmosphere.org
Disclaimer
This product is intended to be used for ENGINEERING DEVELOPMENT, DEMONSTRATION OR
EVALUATION PURPOSES ONLY and is not considered by element14 to be a finished end
product fit for general consumer use. Persons handling the product(s) must have electronics
training and observe good engineering practice standards. The goods being provided are not
intended to be complete in terms of required design and/or manufacturing related protective
considerations, including product safety and environmental measures typically found in end
products that incorporate such semiconductor components or circuit boards.
Typical Setup
Board Features
Gizmo Explorer Board
Quick Start Guide
(Not included)

X-ON Electronics
Authorized Distributor
Click to view similar products for Gizmosphere manufacturer.
Other Similar products are found below :
GIZMO2GSOCD9W10 GIZMOEXPLRBRD