Gladen ONE 201 BMW User manual

DESCRIPTION OF THE CROSSOVERS
GLADEN ONE 201 BMW has to be driven by
a 4-channel amplifier (or two 2-channel amplifiers). It
must have an adjustable high pass on two channels
and an adjustable low pass on two channels.
Connect both woofers (located under the front seats)
to two channels of the amplifier. Set the crossover to
“low pass” and set the cutting frequency on between
100 Hz and 130 Hz.
After the installation of the tweeters and the midrange
speakers in the doors and linked to the crossovers,
connect the crossovers to the two other channels of
the amplifier. The cutting frequency has to be on 180
Hz. If the amplifier scale is not exactly enough, a
higher frequency should be selected.
The level adjustment of the two subwoofer channels
should be set a little bit higher than those of the
midrange/tweeter, according to the individual taste.
The absolute loudness of both channels has to be
adapted to the pre resistance output of your radio.
Connection to the amplifier
Adjusting recommendation:
Cutting the cable loop 1 to reduce the level of the tweeter.
If the original BMW system is without tweeters, the suggestion is to cut both cable loops.
GLADEN ONE 201 BMW
GLADEN ONE 201 BMW EXTREME
Remark:
Tweeter a little bit to loud > cut the cable loop 2
Tweeter or voices hissing > cut the cable loop 1
Please note, that by cars, which have a part-/or active-
system on board, the
GLADEN ONE 201 BMW speaker can be
installed but you need for the on-board radio/amplifier
a processor with signal summing function:
MOSCONI DSP 6to8
MOSCONI DSP 4to6 or 4to6 Dif DSP
GLADEN ONE 120.4 DSP dsp amplifier
MOSCONI HLA-SUM high / low converter.
!

GLADEN ONE 201 BMW modification for installation at BMW 5 line E60/61
Now fit the midrange speaker with the included knurled
screws.
!
At the original metal sheet, on which the midrange
speaker is installed, the fold (see picture) has to be face
grinded, that the GLADEN midrange speaker rests
on the metal sheet.
Mounting the under seat woofer:
Please glue the included round fleece centered under
the original BMW grill (see picture). Attend that the
GLADEN grill don’t hits the BMW grill.
Cut in the carpet and wrap it (see picture) without
covering the speaker.
Operate the system only with a 4-channel amplifier (or with
two 2-channel amplifiers) with adjustable high/low pass filters,
which can be adjusted
Run the system only in this version
Changes or enhancements of the crossover can damage the
speakers or even cause a fire in the car
Never operate the speakers without crossover. Risks of
damage! In this case you will lose the warranty
Please respect all instructions of the car manufacturer and
never perform works which can influence the security of the
car
Too loud music can reduce your attention to the traffic and
can influence your hearing negatively
Security information:
GLADEN ONE 201 BMW
3-way semi-active speaker system:
4x 100 / 150 Watt nominal / music load
Impedance 3 Ohm
4-times adjustable crossover
Technical data:
GLADEN ONE 201 BMW EXTREME
3-way semi-active speaker system:
2x 100 / 150 Watt nominal / music load (Mid-High)
Impedance 3 Ohm
2x 150 / 225 Watt nominal / music load (Woofer)
Impedance 2 Ohm
4-times adjustable crossover