Glasdon COMBO DELTA Manual

COMBO DELTA INSTRUCTION LEAFLET
NOTE: Ensure that all relevant personnel read the points listed below and that a copy is passed on to staff involved
with the installation. Please also refer to the ‘Manual Handling Operations Regulations 1992’ during the handling of the
product and materials used for installation.
P. 1
TM
OPENING AND CLOSING THE UNIT:
INSERTING A SACK:
1. Lift both catches on either side of the door at the same time. Fig 1.
2. Lower the door out until it is resting on the retention straps. Fig 2.
3. To close push the door to until the catches click into place. Fig 3.
1. Hook the open sack over the steel sack band. Fig 4.
2. Lifting the sack band slightly, hook the remaining sack over the two rubber grips located on both
corners of the bin and replace the sack band to ensure a tight t. Fig 5.
Fig 1.
A
Fig 2.
Fig 4.
Fig 5.
Fig 3.

COMBO IS A TRADEMARK OF GLASDON GROUP AND ITS SUBSIDIARIES IN
THE U.K. AND OTHER COUNTRIES.
Replacement components are available direct from GLASDON.
GLASDON cannot be held responsible for claims arising from incorrect installation, unauthorised modifications or misuse of
the product.
Issue 1 February 2012 C000 /0420
© Copyright 2011
Glasdon U.K. Ltd reserves the right to alter specifications without prior notice.
Preston New Road
BLACKPOOL
Lancashire FY4 4UL
Tel: [phone]
Fax: [phone]
E-mail: [email protected]
Web: www.glasdon.com
P. 2
Cleaning
We would recommend a warm pressure wash with soap or alternatively hand wash with 10%
solution of mild detergent in warm water using a soft bristle brush followed by a rinse with clean
water.
Grati
Felt tip pen or paint may be removed from Durapol using Glasdon Gratix Grati wipes or other
proprietary grati remover. Carefully follow the instructions, particularly the guidelines covering
safety. Ensure that all traces of chemicals are removed then clean as detailed above. Please be
aware that grati removers can damage signs and personalisation stickers etc. Protect these areas
when using grati removers.
Maintenance
A planned maintenance schedule of regular inspection is recommended and components
replaced when necessary.
CLEANING AND MAINTENANCE:
TM
GROUND FIXING:
TM
Fig 6.
KIT CONTENTS:
ITEM 1 TLM Fixing Bolts x4
ITEM 2 37mm Plastic Spacers x2
ITEM 3 M10 x 50mm Washers x2
TOOLS REQUIRED:
Hammer
17mm Spanner and Socket Head
Electric Drill
10mm Masonry Drill Bit
Marker Pen
1. Remove the two black hole plugs at the front inside base of the
unit.
2. Using the xing holes as a guide, mark on the ground where the
ground xing bolts will go.
3. Drill the four holes marked to a depth of 55mm using a 10mm
masonry drill.
4. Remove the nut from the xing bolts (Item 1) and slide on the
plastic spacers (Item 2) followed by an ]m10 washer (Item 3).
5. Using the hammer insert the two rear xing bolts into the
ground leaving 65mm protruding above ground. Fig 6.
6. Slide the bin backwards onto the xing bolts ensuring the bolts
are located within the xing recesses. Fig 7.
7. Insert the remaining xing bolts through the front of the unit.
8. Fully tighten all bolts using the supplied nuts until the bin is
securely xed. Fig 8 and 9.
Fig 7.
Fig 8.
Fig 9.