GLITZHOME PATIO WICKER SOFA SET User manual

Assembly Instruction
PATIO WICKER SOFA SET

PRE-ASSEMBLY PREPARATION
WARNING! DO NOT LET CHILDREN PLAY IN OR AROUND THE UNIT DUE TO THE POSSIBLE RISK OF FINGER ENTRAPMENT
•Please read through this instruction before beginning assembly.
•Two adults assembly is recommended.
•Clear out the space for assembly and lay out all parts base on parts List, extra room will allow you to easily
determine if all the pieces are present.
•Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
•Keep small parts and pieces away from children until fully assembly.
•Do not fully tighten the bolts until all have been inserted and hand tightened.
•
•
Please check for any loose screws and tighten them before use.
If there is any questions, please contact us first, we will quickly solve any doubt for you.

PANEL AND FITTINGS IDENTIFICATION
HARDWARE LIST
Back Panel A1 Back Panel A2 Back Panel A3 Seat Panel B1 Seat Panel B2
Ottoman Coffee Table Seat Cushion Back Cushion
Plastic Cap (G)Connector (C) Short Bolt (D) Long Bolt (E) Washer (F)
Wrench (H) Plastic Clip (I)
With a hole here
M6 X 15mm M6 X 35mm
With a hole here
Qty: 2Qty: 2Qty: 2Qty: 2Qty: 2
Qty: 1Qty: 1Qty: 5Qty: 6
Qty: 4Qty: 8Qty: 20 Qty: 28 Qty: 28
Qty: 1Qty: 6

Step 2
Step 1
A2 A3
B1
Aach back panel A2 and A3 to seat panel B1 by using 6 long Bolts (E) and 6 ashers (F).
Finally
put bolt Caps (G) untl all parts have been connected and bolts are ghtened.
Connect the two back panels by using 2 Connectors (C), 4 short Bolts (D) and 4 ashers (F).
Finally
put bolt Caps (G) untl all parts have been connected and bolts are ghtened.
Repeat step 1 and 2 to assemble two corner sofa.
After assembly image
W
W
W

4
I
I
Step 3
Step 4
B2
A1
G
E
F
F
E
G
Atach back panel A1 to seat panel B2 by using 4 long Bolts (E) and 4 ashers (F).
Finally
put bolt Caps (G) untl all parts have been connected and bolts are ghtened.
Repeat to assemble two armless sofa.
Connect the sectonal sofa with two plastc Clips (I) on each side.
W

5
Step 5
Finally put the cushions on. Coner sofa with two back cushions and armless sofa with
one back cushions.