Global Cache Flex Link Series User manual

Flex Link Serial Cable
Quick Start
Global Caché is lessening our carbon
footprint by reducing our paper
output. For complete documentation
and tutorials, visit:
www.globalcache.com/docs
Getting Started. Once the iTach Flex is
connected to the network by either an Eth-
ernet cable or WiFi, plug the Flex Link Se-
rial cable into the Flex Link Port.
To congure Serial cable fuctionality, right
click on the unit entry in iHelp* and click
congure. A web browser will present the
web conguration pages of the Flex. To
access the set up pages manually, type in
the unit’s IP address. Flex units in de-
fault will reside at the default address of
http://192.168.1.70. On the “Flex Link
Port Conguration” page, select “Flex Link
Serial Cable”to congure the settings as de-
sired.
Flex Link Serial cables can be set to either
standard (straight through) or crossover
(null modem) modes by changing the
Quickstart_FLCserial_1up_062713.indd 1 7/1/2013 12:56:09 PM

Global Caché
“Crossover” setting. e default setting of False
puts the Serial cable in standard mode. To
change to crossover mode, select True, then
select Save Changes to apply the new settings.
Disconnecting the Serial cable from the Flex
Link Port will reset all open TCP sockets and
reinitialize the Serial cable. All connections
must be reestablished after unplugging the ca-
ble from the port.
Troubleshooting. See the iTach Flex Quick
Starts or visit our website for more information
on conguring Flex devices.
*To download the iHelp
application visit
www.globalcache.com/downloads. Run iHelp
on a Windows PC that is connected to your
network.
Global Caché, Inc.
160 East California Street
PO Box 1659
Jacksonville, Oregon 97530
Phone [phone] - Fax [phone]
www.globalcache.com - [email protected]
Copyright ©2013 Global Caché, Inc. All rights reserved.
PN: 022213-03 ver.2 Information subject to change without notice.
This device complies with Part 15 of FCC rules and with
ICES-003 of Industry Canada. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference
Made in the U.S.A.
Quickstart_FLCserial_1up_062713.indd 2 7/1/2013 12:56:09 PM