Global 493680 User manual

•When standing on platform, keep legs in the center of
platform to avoid tipping the workbench.
•Do not use excessive force when extending or
retracting legs, this can damage leg supports.
•Be sure all spring loaded pins, hinges, and latches.
Snap, click, and lock into place before use.
•Before use, make sure legs and latches are firmly
locked.
•Do not exceed power ratings listed in the manual.
Refer to Table A
•Do not exceed weight capacities per mode listed in
the manual. Refer to Spec Sheet B
4 in 1 Portable Workbench
Workbench | Work Platform | Creeper | Dolly
Model # 493680
Read this manual thoroughly prior to
installation, operation or maintenance.
Keep these instructions in a safe location
for future reference. For questions,
visit globalindustrial.com or contact
Customer Service at 1-800-645-2982.
ATTENTION
•Ensure that operating instructions are understood
by all personnel capable of using the unit.
•Avoid storing workbench outside or in humid
environments.
1
1Workbench
3 Creeper 4 Dolly
2 Work Platform
WARNING

User's Manual
4 in 1 Multipurpose
Workbench
Modes
Workbench
Work Platform
Dolly
2
Creeper
POWER RATINGS
MAX:
125 Volts
15 Amps
1875 Watts
Weight Capacity
500 lbs
500 lbs
300 lbs
300 lbs
Spec Sheet B.
Table A.
Dolly Mode
Creeper Mode
Use Creeper mode when performing jobs in low
profile spaces. Creeper mode is also used to
efficiently and safely store the workbench.
From Creeper mode, release the four latches on
the sides of the workbench to flip platform panel to
the non-slip surface side.
Holes on side allow for carabiner attachment. Be
sure to pair workbench with equipment that can
handle weight capacity. Refer to Table A.
•3 outlet plugs.
•1 male plug for
extension cable.
•Handle for easy
portability.
DO NOT STEP NOR STAND ON THE
PLATFORM WHILE ON CREEPER MODE.
DO NOT STEP NOR STAND ON THE PLATFORM
WHILE ON DOLLY MODE.

4 in 1 Multipurpose
Workbench
From creeper mode, flip workbench and pull out
spring loaded locking pins and pull each leg up
and out.
Extend leg outward until hinges lock.
HINGES MUST LOCK
From Workbench mode, release the four
latches on the sides of the workbench to
free the platform surface panel.
Press on spring buttons and slide legs to adjust
height. Spring button on each leg MUST CLICK
before using the product.
DO NOT USE PRODUCT IF SPRING BUTTONS
DO NOT CLICK AND/OR HINGES DO NOT LOCK.
1
3
User's Manual
1
22
3
Work Platform Mode
Lift and turn over panel so that the anti-slip
surface is face up. Then re-attach to
workbench.
Workbench Mode
3