Globe GCM-24 User manual

What’s in the box:
• Quick Start Guide
• Centrifuge
• Power Cable
• Rotor
• Rotor Wrench
• Fuses (2 each)
• Door Key (small screwdriver)
GCM-24
Microcentrifuge
Quick Start Guide
UNPACKING THE UNIT
Please be sure to remove any packing materials used during initial shipment:
1) Open the lid: Use the included Door Key to press the buttons
on the right and left sides of the unit.
2) Remove foam pads at the hinge latches.
Continued . . .
INSTALLING AND BALANCING THE ROTOR
IMPORTANT: The rotor should always be loaded in a balanced
manner to avoid personal injury and to ensure centrifuge
longevity.
• When any tube is loaded, a tube of the same type, volume and
weight must be added in the opposite rotor location.
• Never intentionally run the centrifuge in an unbalanced
condition even if operation is not affected.
Locking Nut
Load the Rotor Onto the Shaft Symmetrically Load Centrifuge Tubes Into Rotor
Rotor Lid Knob
Install the Rotor Lid

®
Customer Service, Sales and Technical Support:
Phone: [phone] • 1 [phone]
Fax: 1(201)599-1406•E-mail:mail@globescientic.com
©2019GlobeScienticInc.Allrightsreserved.TheGlobeScienticlogoisaregisteredtrademarkofGlobeScienticInc.GCM-24Guide19107
GCM-24
Microcentrifuge
Quick Start Guide
For the full User Manual, please visit www.globescientic.com
CONTROL PANEL
Speed Display
Temperature Display
Time Display
1
2
34
5
IMPORTANT: Plug unit into appropriate main supply based
on the rated voltage.
Pulse � � � � � � � � � � � � � Press to accelerate and hold at the set
speed. The centrifuge stops immediately
once this button is released.Radius
Door� � � � � � � � � � � � � � Press to open the lid. This button is not
enabled while the centrifuge is running.
Start / Stop � � � � � � � Press to start the centrifuge. Press to
stop if centrifuge is already running.
Select� � � � � � � � � � � � � Press to choose the parameter you wish
to modify.
Adjustment Knob Rotate clockwise to increase parameter
values. Rotate counterclockwise to
decrease parameter values. Press to
switch between speed and RCF.
OPERATION
1
2
3
4
5
Rotor Tube Adapter Maximum Maximum Centrifugal Maximum
Type Type Required Speed (rpm) Radius (cm) RCF (×g)
2.0/1.5mL Tube — 15000 8.5 21380
0.2mL PCR Tube GCM-24-AD2 15000 6.9 17350
0.5mL PCR tube GCM-24-AD5 15000 7.6 19100
0.5mL PCR tube 15000 8.5 21380
  0.2mLPCRStrip GCM-24-AD52 15000 7.6 19100
0.2mLPCRStrip —  6.5/7.2 16350/18100
GCM-24-05ML
(optional)
GCM-24-2ML
GCM-24-PCR
(optional)
The centrifuge rotor can separate samples whose density is lower than 2.0g/ml. If the separated sample’s density is over 2.0g/ml, please
calculate the allowable speed using the following formula:
Allowable Speed (rpm) = Maximum Speed × (2�0(g/ml) / Sample Density (g/ml))1/2