
gure E
Attaching the tether clip to the
gure B
Arrows pointing to support tabs
Attaching
Instructions
7
Make sure tabs align with ribs
at the bottom of the car seat.
Use opening if available
Instructions for attaching your gogo Kidz Travelmate to
your car seat.
NOTE: The Quick Release Strap is pre-assembled onto the plate
of the gogo Kidz Travelmate for use with most car seats. However,
you may need to make adjustments in the length of the strap or
the vertical position of the strap on the gogo Kidz plate. (to t your
particular car seat, see quick release strap adjustments on next
page)
1. Place car seat face down on oor (after the rst time you attach and are
familiar with the product, you may also attach the gogo Kidz Travelmate
to a car seat while in an upright position and with a child siting in seat.
2. Locate the two ribs on each side of your car seat (gure A page 6)
3. Align the two support tabs at the bottom of the gogo Kidz plate with the
bottom ribs (or the bottom of base). (gure B)
4. Lay the gogo Kidz plate at on top of the back of car seat. (gure C)
5. Take the ladder strap (long side of the strap - already attached to the
gogo Kidz plate) and insert through the same opening where you would
put your car seat belt through in the forward position. (gure D)
6. Insert ladder strap into the buckle located on the opposite side of the
gogo Kidz plate and use ratchet to tighten. Tighten securely, but DO NOT
OVERTIGHTEN. (gure D)
7. Pick up your car seat and place in the upright position.
8. Test connection by releasing the handle into the upright position and
pulling/pushing your seat around the room.
9. If your car seat has a tether strap, pull 10" of the strap out and pull
through the handle and attach tether latch to plate handle, tighten strap
to ensure the gogo Kidz Travelmate is secure (figure E) This is especialy
recommended for use with older children.
SPECIAL NOTES
Support Tabs Under Base vs Ribs:Some car seats do not have these
two long ribs in the back. For these types of seats, the support tabs on the
bottom of the gogo Kidz should be located underneath the base itself.
Reclining Seats: The seat recline angle may have to be adjusted in order
to make room for the support tabs or the wheels to t on some car seats.
Britax Seats: Do not place the support tabs underneath the base on
Britax car seats. You must place tabs on the car seat under the ribs on
Britax car seats.
Removable Base: If your car seat has a removable base, you may need
to remove the base prior to attaching the gogo Kidz Travelmate.
Headrest Adjustment: You may be required to move the bar on the back
of your car seat that adjusts the shoulder straps (if equipped) to allow the
handle to sit properly.
ATTACHING THE GOGO KIDZ TRAVELMATE TO A CAR SEAT
gure C
gure D - ladder strap &
ratchet