Quick Start Guide - GB
8
3. Never use any abrasive pad, alkaline/acid cleaner or vola-
tile solvent such as alcohol, benzene.
4. Only use standard accessories, otherwise the device can
get damaged.
5. Do not place the device on a wet or damp surface or aro-
und any containers with water. Keep the projector away from
re and heat sources.
6. Place the projector on a stable surface.
7. Before plug in the power, please make sure the voltage of
your area matches this projector (230V - 110V).
8. Only plug into the three pin plug and make sure you use
ground wire.
9. Before use make sure the cable is not damaged.
10. When there is thunder or when not using the projector
for a long period of time , unplug the power cable.
11. Due to high voltage, do not open or try to repair the
projector by yourself. Refer to a professional technician if
repair is needed.
12. You should not place the projector around any heat so-
urces. It can shorten its life expectancy. Optimal working
temperature of the projector is 0 ~ +40°C.
13. The total voltage of the connected devices shall not be
over 500mA,the problems caused by the wrong operation
will not be warranted.
14. Ensure min. 15 cm of free space around the projector
for its proper ventilation. Do not cover the air holes of the
device.
Correct disposal of this product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other Eu-
ropean countries with separate collection systems)
This marking indicates that at the end of its working
life this product should not be disposed of with other
household waste in the EU.
