Foreword
Thanks for your purchase of this X1T-S TTL wireless flash trigger.
This TTL wireless flash trigger only applies to SONY cameras. It can also directly control
flashes which have built-in Godox wireless X system (e.g. TT685S, V860IIS, AD360II,
AD600, AD600M, QuickerII, etc.). As to the flashes which do not have Godox wireless X
system (e.g.V860, V850, AD360, etc.), a XTR-16 or XTR-16S receiver can be used in
combination to achieve manual flash control. Featuring multi-channel triggering, stable
signal transmission, and sensitive reaction, it gives photographers unparalleled flexibility
and control over their strobist setups. X1T-S can also connect to the cameras which have
PC sync sockets. It supports high-speed sync function and the max flash synchronization
speed is up to 1/8000s *.
*: 1/8000s is achievable when the camera has a max camera shutter speed of 1/8000s.
- 21 -
For Your Safety
- 22 -
To prevent damage to your product or injury to you or to others, read the following safety
precautions in their entirety before using this device. Keep these safety instructions where
all those who use this device will read them.
Failure to observe the precautions listed in this section could result in damage to the
product.
The following icon indicates warnings that should be read before using this device in case
of possible damage or injury.
Do not disassemble or modify
Failure to observe this precaution could result in electric shock or product malfunction.
Should the product break open as the result of a fall or other accident, remove the
batteries and take the product to an authorized maintenance center for inspection.
Keep dry
Do not handle with wet hands or immerse in or expose to water or rain. Failure to
observe this precaution could result in fire or electric shock.
Do not use in the presence of flammable gas
Failure to observe this precaution could result in explosion or fire.
Keep out of reach of children
This device contains small parts which may pose a choking hazard. Consult a
physician immediately if a child swallows any part of this device.
Turn off the transceiver immediately in the event of malfunction
Should smoke or an unusual smell comes from this device, remove the batteries
immediately in case of burning and take the device to an authorized maintenance
center for inspection. Injuries could occur if it is further used.
Do not expose to high temperature
Do not leave the device in a closed vehicle in the sun or in other areas subject to
