Goldair FMX300R User manual

550WStandMixer
Models: FMX300R, FMX310R, FMX300S
Operating Instructions

NEVER
✘Never use this appliance outdoors.
✘Never use this appliance for any purpose
other than its intended use. This appliance is
intended for household use only or in similar
applications such as:
•Staff kitchen areas in shops, offices and
other working environments;
•Farm houses
•By clients in hotels, motels and other
residential type environments;
•Bed and breakfast type environments.
✘This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge, unless they are
supervised or have been given instruction
concerning the use of the Stand Mixer by a
person responsible for their safety.
✘Close supervision is necessary when the
appliance is near children.
✘Never leave the appliance unattended when
in use.
✘Never allow the power cord to overhang the
edge of a table or bench top or to touch any
hot surface.
✘Never place this appliance on or near a hot
gas or electric burner or where it could touch a
heated oven or microwave oven. Do not place
in a hot oven.
✘Never immerse the Stand Mixer‟s power
base, the cord set or plug in water or any other
liquid to protect against electrical hazards.
✘Never place the Stand Mixer in a
dishwasher.
✘Never use harsh, abrasive or caustic
cleaners to clean this appliance.
✘Never operate the appliance with a
damaged cord or plug, after it malfunctions, or
if it has been damaged in any manner. Have
the appliance checked and repaired buy a
qualified electrician if repair is necessary. If the
supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
✘The Stand Mixer is not intended to be
operated by means of an external timer or
separate remote-control system. The use of an
extension cord is not recommended.
✘Never use metal scouring pads for cleaning.
Small metal pieces can come loose and cause
short-circuiting of electrical components, which
can cause electric shock or damage the
appliance.
✘Never exceed the maximum capacity of the
Stand Mixer.
✘Do not operate continuously on heavy loads
for more the 3 minutes.
✘Never continue to operate the Stand Mixer if
an object such as a spoon or spatula or other
item falls into the bowl. IMMEDIATELY turn
speed dial to OFF, turn the Stand Mixer off,
unplug at power and remove the object.
Due to the risk of injury, the use of third
party accessories is not recommended by
the manufacturer. Use only the beater,
whisk and dough hook provided with the
Stand Mixer. Using third party accessories
may cause malfunction, fire, electric shock
or injury.
Thank you for choosing this GOLDAIR Stand Mixer. This GOLDAIR
appliance has been designed and manufactured to high standards
of engineering and with proper use and care, as described in this
leaflet, will give you years of useful service. Please read these
instructions carefully and keep them safely for future reference.
General care and safety guide
TECHNICAL SPECIFICATION
Model No: FMX300R, FMX300S, FMX310R
Power Supply: 220-240V, 50Hz.
Power: 550W

General care and safety guide, continued
WARNING:
To prevent the risk of electric shock this appliance is equipped with a plug for a grounded electrical
outlet that only fits in a matching wall outlet. If the plug dos not fit, contact a qualified electrician for
assistance. Never attempt to change the plug yourself.
To reduce the risk of electric shock or fire do not attempt to disassemble the power base.
There are no components included that could be useful separately. Repairs only by approved
professionals.
ALWAYS
✔Always ensure hands are dry before
handling the plug or the Stand Mixer.
✔Always operate the Stand Mixer in the
middle of a secure, dry, level surface. Do not
operate the Stand Mixer near the edge of a
bench or table. Vibration during operation may
cause the Stand Mixer to move.
✔Always allow adequate air space above and
on all sides for air circulation. Do not allow the
Stand Mixer to touch curtains, wall coverings,
clothing, dishtowels or other flammable
materials during use. Do not use under
cupboards or curtains.
✔Always be sure to set to „off‟ and unplug
from the socket when not in use and before
cleaning.
✔Always allow the Stand Mixer to cool before
cleaning and storing and before removing
and/or cleaning its components.
✔Carry out regular checks of the supply cord
to ensure no damage is evident.
✔Return the Stand Mixer after a malfunction,
or if it has been damaged in any manner, to an
authorised electrical service technician for
examination, repair or adjustment as special
purpose tools are required.
✔Children should be supervised to ensure
that they do not play with the appliance.
✔Ensure the Stand Mixer is completely
assembled before operation. Follow the
instructions provided in this manual.
✔Avoid contact with moving parts and fitted
attachments during operation. In order to
reduce the risk of injury to persons and/or
damage to the mixer, always keep hands, hair,
clothing, as well as spatulas and other utensils,
away from beaters during operation.
✔Ensure the motor and beater, whisk or
dough hook have come to a complete stop
before disassembling or attempting to raise
Stand Mixer head.
✔Remove attachments from the Stand Mixer
before cleaning.
✔Remove and safely dispose of the protective
cover on the power plug. This may present a
choking hazard for children.

Components
1. Motor cover
2. Motor upper housing
3. Small knob
4. Speed switch
5. Lower housing
6. Bottom board
7. Feet
8. Mixing bowl
9. Bowl cover with pouring chute
10. Flat beater
11. Dough hook
12. Balloon whisk

Assembly instructions
Before beginning assembly of product, make sure all parts are present by comparing
parts with components list. Remove all packaging and promotional labels before
assembling Stand Mixer, including the protective plug cover, which may present a
choking hazard for children. Clean all parts gently to remove any manufacturing residue.
The bowl for your Goldair mixer is made from stainless steel. While it is very durable,
stainless steel does require care to maintain its good looks.
Before first use: hand wash, rinse and thoroughly dry your stainless steel bowl to
remove any manufacturing residue.
1. Place the mixer base on a level, dry surface. The mixer motor head should be in the
horizontal position. (Fig.1)
2. Depress the small knob (4) and raise the mixer motor head until it locks into place.
(Fig.2)
3. Place the mixing bowl according to the direction on the base. Turn clockwise to
secure. (Fig.3)
4. Put the bowl lid with pouring chute on the bowl,(Fig.4) Fix and align properly with
bowl (Fig.5)

Assembly instructions, continued
5. Attach Accessory –Place flat mixing
paddle, wire whisk or dough hook into
the accessory power port. Turn
counterclockwise until it locks. Turn
clockwise to remove. (Fig.6 & Fig.7)
6. Lower Mixer Head –Pull up the small
knob again and fully lower the mixer
head. (Fig.8)
Note: You do not need to remove the bowl
cover pouring chute to change
accessories.
Operating your Stand Mixer
To Turn Stand Mixer On
Turn dial to desired speed
We recommend:
1 to 4 for kneading
4 to 7 for mixing
7 to 9 and Max for whipping.
To Turn Stand Mixer Off
Turn switch to “OFF” position.
Ensure your Stand Mixer is turned off and
unplugged before removing or inserting
beater or whisk accessories.
NOTE:
The maximum capacity of the
FMX300/FMX310 Stand Mixer is 800gm
of mix. Overloading will compromise
performance and may damage the
motor.
This machine has a protective feature
that ensures it stops after 10 minutes
continuous running.
In addition, DO NOT operate the Stand
Mixer continuously for more than 3
minutes if you have a heavy load in the
bowl.

Care and cleaning
SUPPORT AND TECHNICAL ADVICE
PO Box 100-707 North Shore City,
Auckland, New Zealand
Monday –Friday 8am-5pm
Phone: [phone]
Website: www.goldair.co.nz
CARE
Never continue to operate the Stand Mixer
if an object such as a spoon or spatula or
other item falls into the bowl.
IMMEDIATELY turn speed dial to OFF,
turn the Stand Mixer off, unplug at power
and remove the object.
DO NOT continuously operate the Stand
Mixer for more than 3 minutes if you have
a heavy load in the bowl.
DO NOT overload the Stand Mixer.
Maximum capacity is 800gm.
CLEANING
Before cleaning, unplug your Stand Mixer
and make sure it cools down.
For the power unit: Wipe with a damp
cloth and dry. Never use abrasive
cleaners. NEVER immerse in water.
Tools: Hand wash only. DO NOT place in
dishwasher. Dry thoroughly.
STAINLESS STEEL BOWL
The bowl for your Goldair mixer is
made from stainless steel. While it is
very durable, stainless steel does
require care to maintain its good looks.
Please read the notes below:
Before first use: hand wash, rinse and
thoroughly dry your stainless steel bowl to
remove any manufacturing residue.
After every use: hand wash, rinse and
thoroughly dry. Leave standing upright for
a period to allow any water trapped in base
of bowl to drain out or dry.
Periodically: use a powdered cleaner or
polisher for stainless steel. Follow the
“grain” of the stainless steel.
Do not use steel wool, a wire brush, bleach
or abrasive cleaners. Steel wool can leave
particles of steel on the bowl, and these
can cause rust marks.
Do not use the stainless steel bowl in
microwave, oven or on a direct heat
source.
Do not place the stainless steel bowl in the
dishwasher.
Metal utensils may scratch the surface of
the stainless steel bowl; this is quite
normal and occurs with all stainless steel.
“Hard” water can cause a discolouration on
stainless steel.
If your stainless steel bowl becomes dull
looking, you may refresh it by sprinkling it
with baking soda while the bowl‟s surface
is wet. Gently rub the bowl, then rinse and
thoroughly dry.

Your Goldair product has been inspected and
tested and is guaranteed subject to the
following for a period to two years from the
date of purchase against defects in
workmanship and materials. During this
period, such defects will be rectified by repair
or replacement of the product purchased.
Your product contains no user serviceable
components and this warranty becomes
invalid if in our opinion the product has been
misused, abused, incorrectly installed,
tampered with, connected to an electrical
supply not corresponding with the name plate
specification, or subjected to power surges.
The warranty does not include any labour or
other associated expense that may be
involved in removal or installation of the
product. Normal wear and tear is expressly
excluded.
If your Goldair product fails to operate
satisfactorily, please return it to the retailer
from whom it was purchased. To obtain a
repair or replacement product under this
warranty, you will need to produce satisfactory
evidence of date of purchase. The completed
warranty and purchase receipt must be
presented with the product. The warranty
should be filled out at the time of purchase. It
is in your interest to make sure this is done.
If the product is to be replaced (cannot be
repaired) then that replacement will be of the
same or similar product or accessory
excluding packaging, instruction card etc.
Where a replacement product is supplied, this
shall be guaranteed for the balance of the
original warranty period.
Any model that is no longer available will be
replaced by a model of a value and with such
features as we consider appropriate in the
circumstances. Goldair Ltd is not responsible
for freight forwarding charges, losses or
damage in transit.
If service is required after the warranty period
has expired, the product should be returned to
a qualified electrical technician. Service
outside of the warranty period will be at your
cost.
Consumers Guarantee Act (1993).
In accordance with the above act consumers
are advised that: The manufacturer does not
undertake that repair facilities and parts are
necessarily available for this product.
If any of the provisions of the foregoing are
contrary to any relevant legislation, then that
provision shall be deemed to be excluded from
the warranty and the rest of the provisions will
continue to apply.
Name ………………………………………………
Address ……………………………………………
……………………………………………………….
Suburb ……………………………………………
Purchased from …………………………………
Date of purchase …………………………………
Name of product …………………………………
Model no ……………………………………………
IMPORTANT: Please retain this warranty card
Two year warranty