Goldair GBS250 User manual
ElectronicBathroomScale
Model: GBS250
Operating Instructions
Your GOLDAIR Electronic Bathroom
Scale is designed with a high precision
sensor system to ensure accurate,
reliable results. The space-saving low
profile design means the scales can be
left out on display, stored in the
bathroom cupboard or under the bed
DO NOT immerse the scale in liquid
nor expose it to excessive moisture.
Store the scale flat, not upright. If the
scale will not be used for a long time,
remove the batteries prior to storage.
Store your scales on a clean, dry and
level surface.
Always weigh yourself on the same
level floor surface, uneven surfaces
may affect readings.
Weigh yourself without clothing or
footwear, before meals and always at
the same time everyday. Every
morning is the best time.
To avoid scratching the glass it is
advisable not to wear any footwear
while taking measurements.
Do not expose the scales to extreme
temperatures.
Do not jump on or drop the scales as
this may lead to your unit measuring
inaccurately.
Use only a dry cloth to clean your
scales. Do not use chemicals.
These scales are designed for use in
the home and should not be used for
commercial purposes.
Thank you for choosing this GOLDAIR Bathroom Scale. This
GOLDAIR appliance has been designed and manufactured to high
standards of engineering and with proper use and care, as
described in this leaflet, will give you years of useful service.
Please read these instructions carefully and keep them safely for
future reference.
General care and safety guide
TECHNICAL SPECIFICATION
Model No: GBS250
Power Supply: 1 x 3V CR2032 Lithium Battery
Features
LCD display
Low battery power indicator
Overload indicator
High precision sensor system
Auto off
Foot tap start
6mm tempered safety glass platform
Auto zero reset
150kg scale in 100gm increments
Lithium battery (included)
Three measurement units: KG/LB/ST
Care and cleaning
Operating your Bathroom Scale
Place scale on a hard, flat surface for an
accurate and reliable result. Do not use on
carpet or rugs. Uneven surfaces may
affect readings.
FIRST TIME USE:
Remove insulation tape from battery
compartment.
TO WEIGH:
Tap the scale gently with your foot. Wait
for the “0.0”to appear.
Step onto scale evenly and stand still. The
scale will automatically display weight in
KG, LB or ST.
AUTOMATIC SWITCH OFF:
The scale will switch off automatically after
8 seconds of idle time.
UNIT OF MEASURE SWITCH:
The scale is set to KG by default. To
switch to LB/ST, press the switch on the
back of the scale.
OVERLOAD INDICATOR:
If the scale is overloaded, the “Err”
message will be displayed.
LOW BATTERY INDICATOR:
If the “Lo” message displays, the battery is
low. Replace the battery –1 x 3V CR2032
Lithium battery is required.
SUPPORT AND TECHNICAL ADVICE
PO Box 100707, NSMC, Auckland
Monday –Friday 8am-5pm
Phone: 0800 232 633
Website: www.goldair.co.nz
Your Goldair product has been inspected and
tested and is guaranteed subject to the
following for a period to two years from the
date of purchase against defects in
workmanship and materials. During this
period, such defects will be rectified by repair
or replacement of the product purchased.
Your product contains no user serviceable
components and this warranty becomes
invalid if in our opinion the product has been
misused, abused, incorrectly installed,
tampered with, connected to an electrical
supply not corresponding with the name plate
specification, or subjected to power surges.
The warranty does not include any labour or
other associated expense that may be
involved in removal or installation of the
product. Normal wear and tear is expressly
excluded.
If your Goldair product fails to operate
satisfactorily, please return it to the retailer
from whom it was purchased. To obtain a
repair or replacement product under this
warranty, you will need to produce satisfactory
evidence of date of purchase. The completed
warranty and purchase receipt must be
presented with the product. The warranty
should be filled out at the time of purchase. It
is in your interest to make sure this is done.
If the product is to be replaced (cannot be
repaired) then that replacement will be of the
same or similar product or accessory
excluding packaging, instruction card etc.
Where a replacement product is supplied, this
shall be guaranteed for the balance of the
original warranty period.
Any model that is no longer available will be
replaced by a model of a value and with such
features as we consider appropriate in the
circumstances. Goldair Ltd is not responsible
for freight forwarding charges, losses or
damage in transit.
If service is required after the warranty period
has expired, the product should be returned to
a qualified electrical technician. Service
outside of the warranty period will be at your
cost.
Consumers Guarantee Act (1993).
In accordance with the above act consumers
are advised that: The manufacturer does not
undertake that repair facilities and parts are
necessarily available for this product.
If any of the provisions of the foregoing are
contrary to any relevant legislation, then that
provision shall be deemed to be excluded from
the warranty and the rest of the provisions will
continue to apply.
Name ………………………………………………
Address ……………………………………………
……………………………………………………….
Suburb ……………………………………………
Purchased from …………………………………
Date of purchase …………………………………
Name of product …………………………………
Model no ……………………………………………
IMPORTANT: Please retain this warranty card
Two year warranty
Other Goldair Scale manuals
