Goldaire GFH130 User manual

Operating Instructions
OscillatingFanHeater
Model: GFH130

General Care and Safety Guide
Thank you for choosing a Goldair Oscillating Fan Heater. This Goldair
Heater has been designed and manufactured to high standards of
engineering and with proper use and care, as described in this leaflet, will
give you years of useful service. Please read these instructions carefully.
1. Use only the voltage specified on the rating label of
the appliance.
2. Keep all objects at least 1 metre from the front,
sides and rear of the appliance. Do not place
appliance close to radiant heat source.
3. Do not operate in areas where petrol, paint or other
flammable liquids are used or stored.
4. Do not insert or allow foreign objects to enter any
ventilation or exhaust opening, as this may cause
an electric shock, fire or damage to the appliance.
Do not sit on the appliance.
5. Do not operate this appliance with a damaged cord,
plug or after the appliance malfunctions or has been
dropped or damaged in any manner. Return to a
qualified electrical person for examination, electrical
service or repair.
6. This appliance is intended for household use only
and not for commercial or industrial use.
7. Use this appliance only as described in this manual.
Any other use is not recommended by the
manufacturer and may cause fire, electrical shock
or injury.
8. The common cause of overheating is deposits of
dust or fluff in the appliance. Ensure these deposits
are removed regularly by unplugging the appliance
and vacuum cleaning the air vents and grills.
9. Do not use abrasive cleaning products on this
appliance. Clean with a damp cloth (not wet) rinsed
in hot soapy water only. Always remove plug from
the mains supply before cleaning.
10. Do not connect the appliance to mains supply until
completely assembled and adjusted.
11. Switch off and use handle provided when moving.
12. Do not operate with cord set coiled up as a heat
build up is likely, which could be sufficient to
become a hazard.
13. It is recommended that this heater is plugged
directly into the wall socket. Power boards are not
rated to supply power to high wattage appliances.
14. A correctly specified, undamaged extension cord
may be used with this heater provided it is used in a
safe manner.
15. Do not remove plug from power socket until the
appliance has been switched off.
16. Do not remove plug from power socket by pulling
cord; always grip plug.
17. Always unplug appliance when not in use.
18. Do not locate the heater directly below any power
socket during operation.
19. Do not twist, kink or wrap the cord around the
appliance, as this may cause the insulation to
weaken and split. Always ensure that all cord has
been removed from any cord storage area and is
unrolled before use.
20. This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities or lack of experience and
knowledge, unless they are supervised or have
been given instruction concerning the use of the
appliance by a person responsible for their safety.
21. Do not use this appliance in the immediate
surrounds of a bath, a shower, or a swimming
pool or other liquids. The appliance must not be
immersed in any liquids.
22. When the appliance has been unpacked, check it
for transport damage and ensure all parts have
been delivered. If parts are missing or the
appliance has been damaged, contact the Goldair
Customer Services Team
23. If your appliance does not work, or is not working
properly, contact the place of purchase or the
Goldair Customer Services Team. Repair work on
the appliance by unqualified persons can cause
serious risk to the user.
24. There are no user serviceable parts installed in
the unit.
25. Do not place the unit in wardrobes or other
enclosed spaces as this may cause fire hazards.
26. This unit is not supposed to be used in or around
locations where foodstuffs, works of art or delicate
articles of science, etc. are stored.
27. Indoor use only.
28. Children should be supervised to ensure that they
do not play with the appliance.
29. Ensure heater is on a flat, stable, heat-resistant
surface.
30. It is important that you do not cover this heater.
TECHNICAL SPECIFICATION
Model No: GFH130
Supply: 220-240VAC 50Hz
Wattage: 2000W

Operating your Fan Heater
SAFETY DEVICE
This appliance has three protection devices:
The first device will automatically turn the appliance
off if the appliance is not in the appropriate operating
position.
The second device automatically disconnects &
reconnects the appliance at a preset temperature.
The third device disconnects the appliance
permanently in case of overheating, by means of a
thermal fuse (it is non resettable).
CARE AND CLEANING
The heater requires regular cleaning to ensure
trouble free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool
down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of
the heater to remove dust and dirt.
Use a vacuum cleaner to remove dust and fluff from
around the grills.
Never use solutions such as benzene, thinners or
polishing agents.
Ensure the heater is dry before plugging back into
the mains supply.
Do not attempt to dismantle the Fan Heater. There
are no user serviceable parts. For service or repair,
contact an authorised electrical service technician.
CAUTION
The Fan Heater generates heat during use. Proper
precautions must be taken to prevent the risk of
burns, scalds, fires or other damage to persons.
Do not use this heater with a programmer, timer,
separate remote-control system or any other device
that switches the heater on automatically.
WARNING Keep all objects at least 1 metre
from the front, sides and rear of the
appliance.
HEAT CONTROL SWITCH
The control switch positions are:
“0”= OFF
= Fan Only
“I” =Low Heat
“II” = High Heat
Check that the heat control switch is set to Off
position before plugging the heater into the
mains supply. For greater economy, use the
High Heat setting initially and then switch to the
Low Heat setting.
For the Low and High Heat settings the fan
remains at the same speed; only the element
changes to create the greater/lesser heat output.
OSCILLATE
The button on the base of the unit turns the
heater oscillation function on and off.
THERMOSTAT
Turn the thermostat knob clockwise until you
reach the maximum temperature on the
graduated scale. When the desired room
temperature is reached, slowly turn the knob
anti-clockwise until the heater turns off (you will
hear a click). The heater will now cycle on and
off to maintain the set temperature.
IMPORTANT! NEVER COVER THIS HEATER!
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase.
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
Goldair –New Zealand
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[email protected]z
Goldair –Australia
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[e-mail]
SUPPORT AND TECHNICAL ADVICE

Thank you for purchasing this Goldair product. Your product is warranted against faults and manufacture when used in
normal domestic use for a period of two years. In non-domestic use Goldair limits the voluntary warranty to three
months.
Goldair undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault
during the warranty period.
This warranty excludes damage caused by misuse, neglect, shipping accident, incorrect installation, or work carried out
by anyone other than a qualified electrical service technician.
PLEASE KEEP YOUR RECEIPT AS THIS WILL HELP VERIFY YOUR WARRANTY.
The benefits given to you by this warranty are in addition to other rights and remedies available to you under law in
relation to the goods or services to which this warranty relates.
In Australia, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure.
In New Zealand this warranty is additional to the conditions and guarantees of the Consumers Guarantee Act (1993).
Two Year Warranty
Goldair Two Year Warranty (IMPORTANT: Please complete and retain this warranty card)
Name
Address
Place Of Purchase Date Of Purchase
Name Of Product Model Number
Attach a copy of the purchase receipt to this warranty card
Due to continual design improvements, the product illustrated in this User Manual may differ slightly from the actual product.
Goldair –New Zealand
CDB Goldair
PO Box 100-707
N.S.M.C
Auckland
Phone [phone]
Phone [phone]
www.goldair.co.nz
Goldair –Australia
CDB Goldair Australia Pty
PO Box 574
South Morang
Victoria, 3752
Phone [phone]
Phone 1300 GOLDAIR (1300 465 324)
www.goldair.com.au