Goldmedal 5582 User manual

Part No. 38475
Cheese Display Case
Instruction Manual
Models #5582 & #5583
CINCINNATI, OH 45241-4087 USA

SAFETY PRECAUTIONS

Cheese Display Case
3
Installation Instructions
Inspection of Shipment:
Unpack all cartons and check thoroughly for any damage that may have occurred during
transit. Damage claims should be filed immediately with the transportation company.
Gold Medal Products is not responsible for damage that occurs in transit.
Setup:
Your new Cheese Display Case is assembled and tested at the factory.
Remove all packing material and tape before starting operation.
Electrical Requirements:
The following power supply must be provided:
5582: 120v, 60Hz, 528W, 4.4 amps
5583: 120v, 60Hz, 603W, 5.03 amps
Your electrician must furnish sufficient power for proper machine operation. We
recommend this Display Case be on a dedicated and protected circuit. Failure to wire
properly will void the warranty and may result in damage to the machine.
It is Gold Medal Products Company’s recommendation that this machine be plugged
directly into a wall outlet. The use of extension cords is not recommended due to safety
concerns, and may cause sacrificed and/or reduced performance.
Before You Plug In Machine:
1. Make sure the wall outlet can accept the grounded plugs (where applicable) on the
power supply cord.
2. The wall outlet must have the proper polarity. If in doubt, have a competent
electrician inspect the outlet and correct if necessary.
3. DO NOT use a grounded to un-grounded receptacle adapter.

Cheese Display Case
4
Operating Instructions
Controls and Their Functions:
The lighted rocker switch controls the element, blower fan and light bulbs. The fan
circulates air over the thermostat controlled element which keeps the cheese portion
packs warm inside the cabinet.
Care and Cleaning:
The stainless steel cabinet can be kept clean by using a warm, damp cloth to remove all
dirt and grease spots. The acrylic doors should also be kept clean. DO NOT use
ammonia based cleaners. Clean the inside and outside of the acrylic doors with a soft
cloth and a non-abrasive cleaner.

MAINTENANCE INSTRUCTIONS

ORDERING SPARE PARTS
* Always speak to a Gold Medal Products Technical Service Advisor before
ordering any parts to help ensure accuracy for your product. Included
diagrams may not be the latest information.
1. Identify the needed part by checking it against the photos, illustrations, and/or parts list.
2. When ordering, please include part number, part name, and quantity needed.
3. Please include your model name, serial number, and date of manufacture (located on
the machine nameplate) with your order.
4. Address all parts orders to:
Parts Department
Gold Medal Products Co.
10700 Medallion Drive
Cincinnati, Ohio 45241-4807
Or, place orders by phone or online:
[phone]
[phone]
Fax: [phone]
E-mail: [email protected]
Web Page: www.gmpopcorn.com

Cheese Display Case
7
Cabinet Assembly

Cheese Display Case
8
Item Part No. Description
1 47422 Light Bulb, Clear 7½ Watt (x2)
2 75040 Incandescent Lampholder (x2)
3 48018 Exhaust Blower
47199 Blower Plug & Cord - Not Shown
4 38503 Nacho Cheese Sign (5582)
38504 Nacho Cheese Sign (5583)
5 38448L Hinge, Left Side (x2)
6 42532 Switch, DPST Rocker
7 47120 Knob
8 75267 Tee Bolt
9 38451 Heat Sink Plate (x2)
10 38533 Thermostat, 145°F
11 47236 Snap Bushing - Not Shown
12 47561 Magnetic Catch
13 22038 Lead-In Cord, 15 amp Plug
14 87194 Strain Relief
15 38534 Heat Element, Tubular 120V 400W
16 38473 Cover, Light Wires (x2) (5582)
38474 Cover, Light Wires (x2) (5583)
17 38439 Bottom Plate, Cabinet (5582)
38466 Bottom Plate, Cabinet (5583)
18 38447 Acrylic Panel (x2) (5582)
38470 Acrylic Panel (x2) (5583)
19 47328 Glide (x4)
20 38440 Retainer, Display Sign (5582)
38467 Retainer, Display Sign (5583)
21 38428 Door 1/8 Acrylic (5582)
38455 Door 1/8 Acrylic (5583)
22 47264 Spacer, Thermostat Mount (x4)
23 79058 Thermostat, High Limit
24 38536 Clamp, Tubular Element
25 38429 Rack Assembly - Not Shown (5582)
38456 Rack Assembly - Not Shown (5583)
Parts List – Cabinet Assembly

Cheese Display Case
9
Electrical Schematic – 5582 & 5583

WARRANTY
WE WARRANT to the original purchaser the Gold Medal equipment sold by us to
be free from defects in material or workmanship under normal use and service. Our
obligation under this warranty shall be limited to the repair or replacement of any
defective part for a period of six (6) months from the date of sale to the Original
Purchaser with regard to labor and two (2) years with regard to parts and does not
cover damage to the equipment caused by accident, alteration, improper use, voltage,
abuse, or failure to follow instructions.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES EXPRESSED
OR IMPLIED, AND OF ALL OTHER OBLIGATIONS OR LIABILITIES ON OUR
PART, INCLUDING THE IMPLIED WARRANTY OF MERCHANTIBILITY.
THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION
ON THE FACE HEREOF. We neither assume, nor authorize any other person
to assume for us, any other obligation or liability in connection with the sale of said
GOLD MEDAL equipment or any part thereof.
The term “Original Purchaser” as used in this warranty shall be deemed to mean that
person, firm, association, or corporation who was billed by the GOLD MEDAL
PRODUCTS COMPANY, or their authorized distributor for the equipment.
THIS WARRANTY HAS NO EFFECT AND IS VOID UNLESS THE ORIGINAL
PURCHASER FIRST CALLS GOLD MEDAL PRODUCTS COMPANY AT 1-800-
543-0862 TO DISCUSS WITH OUR SERVICE REPRESENTATIVE THE
EQUIPMENT PROBLEM, AND, IF NECESSARY, FOR INSTRUCTIONS
CONCERNING THE REPAIR OR REPLACEMENT OF PARTS.
GOLD MEDAL PRODUCTS COMPANY
10700 Medallion Drive
Cincinnati, Ohio 45241-4807 USA
www.gmpopcorn.com
Phone: [phone]
Fax: [phone]
© The text, descriptions, graphics and other material in this publication are the proprietary
and exclusive property of Gold Medal Products Company and shall not be used, copied,
reproduced, reprinted or published in any fashion, including website display, without its
express written consent.