Hot Dog Roller Grill Model No. 8022, 8022PE, 8023, 8023PE, 8023SL, 8024, 8024PE, 8024SL, 8025, 8025SL
http://www.gmpopcorn.com Page
4
INSTALLATION INSTRUCTIONS
Inspection of Shipment
After unpacking, check thoroughly for any damage which may have occurred in transit. Claims should be filed
immediately with the transportation company. The warranty does not cover damage that occurs in transit, or
damage caused by abuse, or consequential damage due to the operation of this machine, since it is beyond our
control (reference warranty in back of manual).
Manual
Read and understand the operator’s manual and all other safety instructions before using this equipment. To
order copies of the operator’s manual go to gmpopcorn.com or write to Gold Medal Products Co., 10700
Medallion Drive, Cincinnati, OH 45241 USA 1-(800)-543-0862.
Setup
This unit has been tested at the factory. Remove all packaging and tape prior to operation. Place unit on a
sturdy, level base.
After setup, the unit should be cleaned prior to use (see Care and Cleaning section of this manual).
Electrical Requirements
The following power supply ust be provided:
8022, 8022PE: 120 V~, 550 W, 60 Hz
8023, 8023PE, 8023SL: 120 V~, 1350 W, 60 Hz
8024, 8024PE, 8024SL: 120 V~, 1000 W, 60 Hz
8025, 8025SL: 120 V~, 1300 W, 60 Hz
Machine must be properly grounded to prevent electrical shock to personnel.
Failure to do so could result in serious injury, or death.
DO NOT immerse any part of this equipment in water.
DO NOT use excessive water when cleaning.
Keep cord and plug off the ground and away from moisture.
Always unplug the equipment before cleaning or servicing.
Make sure all machine switches are in the OFF position before plugging the
equipment into the receptacle.
008_051514
Your electrician ust furnish sufficient power for proper achine operation. We reco end this
equip ent be on a dedicated and protected circuit. Failure to wire properly will void the warranty and
ay result in da age to the achine. It is Gold Medal Products Co.’s reco endation that this achine
be plugged directly into a wall outlet. The use of extension cords is not reco ended due to safety
concerns, and ay cause sacrificed and/or reduced perfor ance. Make sure cord is located to prevent a
trip hazard or unit upset.
