GOODRICH Extra 300 User manual

1.5mm
COLLAR 2.1mm w/set screw
(For Main Landing Gear) -- 2 sets
NUT M2mm（For Axle）-- 2 pcs
HAMULUS--2 pcs
12. PUSHROD :--
METAL ROD Ø1.2x340mm
(For Rudder Servo)--1pc.
METAL ROD Ø1.2x340mm
(For Elevator Servo)--1pc.
METAL ROD Ø1.2x80mm
(For Alieron Servo)--2 pcs
13. HORN -- 4 sets
14. WOODEN PARTS : --
WOODEN 235x12x3mm (Wing Joiner) --1 pc.
PLYWOOD 15x15x2mm (For Wheel Pants) --2 pcs
15．ELASTIC BAND--2 pcs
16. DECALS -- 1 set
17. MANUAL -- 1 pc.
1.FUSELAGE --1 pc.
2.MAIN WING --1 pair
3.STABILIZER & ELEVATOR --1 set
4.VERTICAL FIN & RUDDER --1 set
5.CANOPY --1 pc.
6.COWLING --1 pc.
7.MAIN LANDING GEAR 2mm --1 pc.
8.TAIL LANDING GEAR --1 pc.
9.MAIN WHEEL ?40mm --2 pcs
10.WHEEL PANTS --1 pair
11.METAL PARTS: --
SCREW PWA2.3 x 8mm(For Cowling) -- 4 pcs
SCREW PA3x8mm(For Motor Mount) -- 4 pc.
SCREW PA3x8mm(For Main Linding Gear) -- 3 pc.
SCREW PM2 x 25mm（Axle）-- 2 pcs.
SCREW PM2 x 8mm（For Horn）-- 4 pcs.
SCREW PM2 x 12mm（For Aileron Horn）-- 4 pcs.
WASHER d2mm（For Axle）--2 pcs

CA
PM2x12mm
Horn
1.5mm
1.5mm
2 Aileron Servo

2mm
Front
Top View
1.5mm
PM2x8mm
Elevator Pushrod
PM2x8mm
1.5mm
Rudder Pushrod

9 Main Wing
8 Brushless Motor
7 Linding Gear
P.4
Wing Joiner
235 x 12 x 3mm
PWA2.3 x 10mm
PWA3X8mm
Motor Mount
Back Mount
KM3X6mm
1.5mm
Nut
M2mm
2.1mm
Plywood
15x15x2mm
AB
3X4mm
PA3x8mm
PM2x25mm
Washer
d2mm
Collar
d2.1mm
Wheel
38mm

12 Fuselage
Ｐ．５
11 Cowling & Canopy
PWA2.3x8mm 1.5mm
Magnet
retention
Top View
Elastic Band
10 Fuselage
Bottom View
97mm

Elevator
Rudder
Aileron
P.6
2．4in.
60mm
C.G.
8mm
8mm
12mm
12mm
30mm
30mm
Adjust maximum control throws as shown in the
diagrams. Set you radio dual-rate switches for 60%
on both elevator and aileron throws for first flights.
Adjust according to your preference thereafter.
Set balance position (CG) to 60mm (2．4¡±) from leading edge
of wing, measured where the wing meets the fuselage for first flights．
To obtain this balance, move the battery forward or backward as
required. Move CG rearward little by little during subseauent flight,
To your preference.