Gotrax EBE1 User manual

EBE1
USER MANUAL
ELECTRIC BIKE

ALWAYS wear a helmet when riding your electric bike.
Make sure your electric bike has a full battery before taking it out to ride.
Always be aware of local road laws, and follow them.
Do not ride the bike under the inuence of drugs or alcohol.
Always respect pedestrians.
Do not ride under wet conditions. The electric bike may slide from under your
feet causing injury. Wet conditions may damage the electronics and void the
warranty.
Don’t Ride Until You Read This:

1. Avoid water - The electric bike is not waterproof. The electronics may be damaged
due to water and water damage is not covered by our warranty. Riding in wet
conditions is also very dangerous and may result in injury.
2. Avoid prolonged exposure to sun or rain and avoid storage in places with high
temperatures or corrosive gas.
3. Abuse - We do not cover physical damage due to negligent care and extreme riding.
4. Whenever you ride the GOTRAX Electric Bike, you risk severe injury or even death
from loss of control, collisions, and falls. Use caution and ride at your own risk.
5. Do not modify the product from the manufacturers original design.
6. Do not exceed the posted speed limit and obey all trac laws.
7. Avoid touching the charging port directly and do not let it make contact with a
metal object.
8. Keep hands and all body parts away from moving parts while operating the
electric bike.
9. Before riding - be sure to check the electric bike over and make sure the electric
bike is operating correctly before each use.
10. Before riding - be sure to check that the braking system is functioning properly;
also be sure to check that all safety labels are in place and you understand the
safety warnings.
11. Before riding - be sure that any and all axle guards, chain guards, or other covers
or guards supplied by the manufacturer are in place and in serviceable condition.
12. Before riding - be sure to check that the tires are in good condition, inated
properly, and have sucient tread remaining.
Warning Message

13. Never exceed the 265 lb maximum load rating.
14. The electric bike should never be used by children under the age of 16.
15. Maximum Speed - Your electric bike goes the maximum speed of 15.5 mph.
16. Make note that additional insurance may be required to cover situations you
encounter while riding an electric bike. It is recommended that you contact an
insurance company or broker for advice and consultation.
17. To conserve electricity, use assist mode and avoid zero starting, frequent braking,
driving against the wind, carrying heavy loads including other people and riding with
insucient air pressure.

Remove all packaging material, then inspect each item for any accidental damage
that may have occurred during shipping. You should nd each of these items in
your box:
Unpacking and Product Specs
13 2
ELECTRIC BIKE TOOLS: (1) LARGE WRENCH, (3)
ALLEN WRENCHES
BATTERY CHARGER
ITEM SPECIFICATIONS
Model EBE1
Product Dimensions 86x38x65 (cm)
Package Dimensions 150x24x102 (cm)
Max Load 265 lbs
Package Weight 55.5 lbs
E Bike Weight 44.9 lbs
Max Speed 15.5 mph
Battery 36V7.5AH
Pedal-Assist Mode Approx 28 miles (45 km)
Pure Electric Mode Approx 15.5 miles (25 km)
Max Angle of Climb 14 degrees
Charging Time 4-5 hours
Charger Input 100-240V 50/60HZ AC plug; output 42v2a DC 2.1 charging port
Tire Pressure 35-45 PSI
Bell/Horn Specications Electric Horn Installed
Charging Port 5V1A
Frame Material 6061 Aluminum Alloy
IP Level IPX4

Get To Know Your E-Bike
Saddle
Seat Post
Motor
Wheel Chain
Crankset
Pedal
Removable
Battery
Tire Disc Brake
Suspension
Front Fork
Front Light
Stem
LCD Display

1
Basic Operation Guidelines
2
Adjust the position of the handlebars Adjust the basic operation of the riser
folding
34
Take note of the locking safety part of
the body folding mechanism
Adjust the brake

1
Adjusting the Seat Tube
2
Push the saddle down Open the lever of the seat tube
34
Adjust and rotate the seat Lock the leve.

1
Mounting Pedal
2
Check the L and R marks on the pedals Take wrench from the toolbox
34
R means it should be installed on the
right side, L means it should be installed
on the left side
Tighten the nut counterclockwise

Before using the electric bike, you must fully charge the battery.
Charge Your E-Bike: Method 1
1. Locate the charging port
2. Plug the charger into a power supply
3. A red light indicates the battery is charging, green indicates the battery is full
4. Charging Time: 4-5 hours
Charging
Port

Pre-Ride Preparation
1. Please read this manual to understand the performance and related
requirements of the product.
2. Check the condition of the whole vehicle: carefully check the brake, tire,
handlebar, folding buckle and quick release parts of the power folding vehicle.
3. Check the circuit system: whether the battery is enough to support the required
range. If the battery power is insucient, you must rst charge it.
4. Check the brake system: Whether the brake and the brake power-o function are
normal. If brake power-o function fails please suspend the use and contact our
customer service in time.
5. Insert the riser at a depth not less than the minimum depth (with the safety
line as the minimum depth) and lock the quick lock. (see gure below)
6. The height of saddle tube can be adjusted according to personal preference, but
the insertion depth shall not be lower than the minimum insertion depth (take the
safety line as the minimum depth) to ensure safety and lock the quick lock. (see
gure below)
1 2

Adjust the saddle pipe and crank, loosen
the saddle pipe clamp for quick removal.
Insert the saddle tube downward to the
bottom and lock the saddle pipe clamp for
quick removal. Crank angle adjusted to 9
o'clock.
Fold the riser to adjust the T handle. Loosen
the riser safety ring. Open the riser folding
handle. Fold the upper end of the riser
downward and adjust.
Fold the frame and open the safety hook of
the frame folding device. Open the frame
folding handle to make the front wheel fold
to the rear wheel and complete the folding.
1
3
2
Folding the Electric Bike

Basic Operations/Modes
1. Power Assist: Open the switch lock, step on the foot pedal.
2. Pure Electric Mode: When the key is opened, turn the right-hand handle, and ride
in pure electric mode.
3. Human Mode: Without turning on the key switch, the human mode can be selected
by directly stepping on the foot pedal.
SAFETY NOTES:
• Do not plug and pull the handle when it is powered on.
• Try not to bump the handle
• Don't change the background parameter setting of the speed regulating handle,
otherwise you can't guarantee normal riding. If it is not, contact customer service as
soon as possible and do not use.

Battery Information
Before using the charger locate the voltage selector switch (li-ion chargers only) on
the back of the back of the charger. Select either 115 volts or 230 volts depending on
your country of residence. Using the wrong voltage setting will permanently damage
the charger and/or electrical components on the hybrid electric bicycle.
BATTERY ASSEMBLY
1. Use the matching charger.
2. Insert the round plug into the E-Bike rst and then insert the charger plug into the
electrical socket.
3. A red light indicates the battery is charging.
4. A green light indicates the battery is fully charged.
5. The lock position will vary from model to model.
6. The Battery is removable, the battery can be charged attached to the e-bike or
pulled out and charged separately.
7. Anti-theft system of the battery: There is a hole under the frame. Where we can use
the key to lock it.

Battery Information
CHARGING THE BATTERY
1. When using the charger for the rst time, carefully check whether the rated output
voltage of the charger is consistent with the battery voltage and check whether the
charger input voltage is consistent with the grid voltage.
2. When charging, rst put the charger in a ventilated place, then insert the charger
output plug into he charging port. Plug the electrical power plug into the 100-240V
50 HZ AC Power Supply. Be sure to keep the input plug in contact with the AC outlet.
3. After charging, the input plug of the charger shall be pulled out rst, and then the
output plug connected with the folding car shall be pulled out. Do not connect the
charger to the charged power socket for a long time without charging.

PRECAUTIONS FOR BATTERY PROTECTION
1. Do not place anything on the battery and charger when charging, otherwise the
charger may overheat and cause serious consequences.
2. Please use the charger supplied by the original factory to charge the battery, if you
use other than the original factory charger your battery will be disqualied from
warranty.
3. You can charge your battery at any time if the battery loses power.
4. If you do not charge in time, your battery will gradually lose its performance and
reduce it's service life.
5. Protection can make your battery maintain about 80% of its capacity after more
than 500 charges. But overall decline is inevitable.
6. If the battery remains in a state of power loss for a long time, it will lead to
permanent loss of performance.
7. If you want to store your battery for a long time, please store and discharge it in a
cool and dry place.
8. Keep the temperature between 10-21° C and avoid direct sunlight. Take the battery
out for charging every 30 days.
9. Do not intentionally short-circuit the battery which will cause very serious
consequences.
10. After the battery life has reached, do dispose of your batteries responsibly be
researching local recycling regulations.
11. If you have questions about battery use, maintenance or storage, please contact
customer service at anytime.

Repair and Maintenance
1. The front and rear wheels of the vehicle should be located in the center of the front
fork or frame, and the expansion force of each spoke of the wheel rim should be
similar. Keep the wheel rim in a regular circle, without run out or oset connection.
If there are missing or broken spokes, it will make the rim less smooth. Find a
professional technician for debugging.
2. The rim must be smooth. If it is not smooth, it will increase the riding resistance or
cause danger.
3. Your folding car is equipped with high-quality drive chain, so please keep the chain
clean and add it frequently. Use clean oil for continuous lubrication.
4. Please check whether the brake pads are worn before each ride to ensure the
safety during the ride.
5. Please avoid riding in wet or snowy weather. If it is unavoidable remember to brake.
6. Check the tires frequently for any scar, crack or excessive wear. The inner tube
and air nozzle should be perpendicular to the rim. It can be crooked. Damaged or
excessively worn tires need to be replaced immediately. Please nd a professional
technician to replace your tire. If your tire accidentally punctures and leaks, please
contact a professional technician to repair or replace it.

Riding Precautions
1. The cruising mileage of the power folding vehicle will be aected by the battery
charging condition, tire ination, the power gear your choose and riding. The
inuence of factors such as the weight of passengers, terrain, whether or not to
start or stop constantly.
2. Before each ride, check whether the battery is fully charged, whether the tire
pressure is normal and check the brake distance. The left handbrake handle
corresponds to the rear brake and the right handbrake handle corresponds to the
front brake.
3. Wear a safety helmet with proper size.
4. When parking, please switch the power gear to 0 or hold the brake tightly.
5. Abide by trac laws and regulations, please ride on the right edge of the road, do
not go retrograde.
6. Your power bicycle has been installed with the required reector according to the
national standard. The reector is clean and bright do not remove the reector
without permission.
7. Look for professional technicians to maintain your power folding car, adjust the
brake, transmission and other parts.
8. Please do not upgrade or add spare parts without conrming with customer service
because modications that have not passed the safety and reliability tests from the
original factory pose a safety risk.
9. Gradually increase the gears
10. When climbing a steep slope, the gear should not exceed the "2" gear.

Troubleshooting & Warranty
We frequently update our user manuals at GOTRAX.com, and reserve the rights to
update and change manuals online.
Please contact our customer service team if you are experiencing problems or need more
detailed information. They can be reached at GOTRAX.com
1. Users should operate in accordance with the product manual. In case of any
performance fault caused by production quality, the company shall perform the
obligations of the three guarantees in accordance with the provisions of relevant laws
and regulations of the state.
2. The company is still responsible for the after-sales service of the faults beyond three
guarantees and the major components in the three guarantees, but there will be a
cost for repair.
3. If the battery replacement is over the warranty time, our company will supply the
battery at factory price. To ensure safety, and avoid pollution.
For additional warranty information, please visit GOTRAX.com.