Gotrax VIBE Scooter User manual

VIBE Scooter
USER MANUAL
C O M M U T I N G E L E C T R I C S C O O T E R

Congratulations
on your purchase!

This user manual will help you assemble and
operate your new electric scooter. Be sure to read
ALL OF THE INFORMATION in this manual
before riding.
NOTE TO ALL RIDERS UNDER 18 YEARS OF
AGE: It’s very important that you get parental
permission before riding your scooter.

ALWAYS wear a helmet when riding your electric scooter.
Make sure your scooter has a full battery before taking it out
to ride.
Always be aware of local road laws, and follow them.
Do not
alcohol.
Always respect pedestrians.
Do not ride under wet conditions. The scooter may slide from
under your feet causing injury. Wet conditions may damage the
Don’t Ride Until You Read
This:

1. Avoid water -The scooter is not waterproof. Theelectronics may be damaged
due to water and water damage is not covered by our warranty. Riding inwet
conditions is also very dangerous and may result ininjury.
2. Abuse -We do not cover physical damage due to negligent care and extreme
riding.
3. Whenever you ride the Gotrax scooter , you risk severe injury or even
death from loss of control, collisions, and falls. Use caution and ride at your own
risk.
4. Do not modify the product fromthe manufacturers original design.
5. Keep hands and allbody parts away frommoving parts while operating the
scooter.
6. Before riding - be sure to check the scooter over and make sure the scooter is
operating correctly before each use.
7. Before riding - be sure to check that the braking system is functioning properly;
also be sure to check that all safety labels are inplace and you understand the
safety warnings.
8. Before riding - be sure that any and all axle guards,chain guards,or other
covers or guards supplied bythe manufacturerare in place and in serviceable
condition.
9. Before riding
10. The electric scooter should never be used under the age of
11. Maximum Speed -Your electric scooter goes the maximum speed of 12 mph.
12. Never exceed the 176 lb maximum load rating.
Warning Message
13.

1. Electric Scooter
2. Console & Handlebars
3. Approved Power Adapter / ChargingUnit
4. AllenWrench
5. Screws
Remove all packaging material, then inspect each item for any accidental
damagethat may have occurred during shipping.
Unpack
1 2 345

The G2 Scooter comes partially assembled.
GET TO KNOW
YOUR SCOOTER
Tiller
Accelerator ( throttle)
The electric scooter comespartially assembled.
Get To Know Your Scooter
Top Speed:
Distance per Charge:
Battery Type:
Battery Charger:
ChargeTime:
Power Requirements:
12 mph
7 miles
36V 4.0Ah
DC 42V 0.85A
AC 100 240V
~50/60HZ1.5A
Headlight
Tiller
Hub Motor
Accelerator (throttle)
Console
ChargerPort
Hook
Brake (left thumbthrottle)
Folding System
Fender Buckle
Rear Fender
Kickstand
4.5 - 5 hours

the folding hook and fender buckle, then
Once the scooter is locked in the upright
Unfold Scooter & Lock
in Upright Position
Use the Allen wrench to loosen the screws
located at the hook and detach. Once
of the tiller.
Detach Hook and Remove
Plug Inside Tiller
Once the console is attached, use the Allen
wrench to attach the hook back to the tiller
with the two screws.
Place Console Into Tiller
& Reattach
Assemble Your Scooter
1
2
3

Before using the scooter, you must fully charge the battery.
Charge Your Scooter

2. Insert the charging plug into the port.
light when charging.
clear of dust and debris.
To power the scooter on , press and hold the red
button for 1 seconds.
, press and hold the red
button for 5 seconds.
, press the red button for 1 second
while the scooter is powered on.
The console on the Scooter displays speed in MPH , Battery life, and
headlight on/off.
Scooter Console Functions

1. You will want to start riding your scooter with one foot on the platform and one
foot on the ground. Use your foot on the ground to push off and at the same
rear fender foot brake.
3. The scooter performs best when on a smooth surface e.g. carparks, smooth
roads, footpaths, & bike lanes.
to be maintained.
5. Do not press the throttle while walking with the scooter beside you.
6. Be aware of the terrain you are riding on, watch out for curbs and obstacles!
7. Cruise Control:
8. CAUTION
Magnetic brake. This brake is energized by the operation of the motor and will
Riding Tips

Before foldingthe scooter, make sure that the scooter is powered off. .
Folding: Ensure the electric scooter is powered off, holdthe tiller and pull outthe
spring pin onthe right folding panelthen rotate the spring pin counterclockwise. Insert
the hook on the tiller into the loop onthe rear fender buckle. You may hear a click
which indicates that you were successful infolding and lockingthe scooter.
Unfolding: Press the rear fender and pullthe tiller upto unfold the electric scooter,
the spring pin will insert itself in place within the folding lever to lock the folding
mechanism.
Putting Your Scooter
Away/Folding
1 2

If you regularly clean and maintain your electric scooter, it will
extend its life.
Cleaning and storage: If the scooter is dirty, wipe it clean with a soft
damp cloth.
Brake Adjustments & Service: If you notice you need brake adjustments
will adjust and repair your scooter. Do not repair your scooter yourself, this
DO NOT
to the electronics.
Storage:
appearance and may cause wear on the life of the battery and tires.
Tightening the Tiller: If you notice that the tiller is loose or wiggles while
wrench to tighten the screws.
Maintenance & Repair

Make sure to store your scooter and power adapter in conditions that do
Warning
materials, store indoors when not in use.
Battery Information
gotrax.com
rights to update and change manuals online.
Please contact our customer service team if you are
experiencing problems or need more detailed information.
They can be reached at gotrax.com
Troubleshooting
www.gotrax.com .
Warranty

W W W .GOTRAX. C O M
#RideGOTRAX

GOLABS, INC
GOTRAX.com
2201 Luna Rd.
Carrollton, TX 75006