06 GoVision Apollo User Guide
ON/OFF
Press and hold down the on/off button (1) until the red LED
power indicator Light (2) turns on and the glasses vibrate
before releasing the button with your finger to turn on your
GoVision. GoVision will automatically enter video recording
mode once the glasses have been turned on. The red LED
power indicator light (2) will flash while recording.
To Power off the glasses, hold down the on/off button (1)
for two seconds and the red LED power indicator light
(2) will turn off and the glasses will vibrate automatically
saving the files and shut down.
RECORDING VIDEO
Power on the glasses by holding down the on/off
button (1). The red LED power indicator light (2) will turn
on and the glasses will vibrate. After you feel the vibration
you can release your finger from the on/off button (1).
Once powered on the glasses will automatically enter into
video record mode. To Stop recording, press the on/off
button (1). The system will automatically save video files
in 10 minutes increments.
USER GUIDE
LIFE THROUGH
YOUR EYES
SEE IT. RECORD IT.
SHARE YOUR LIFE
GoVision Apollo User Guide 07
In order to ensure good sound quality, make sure you do
not block the microphone.
To keep the glasses from water damage, please make sure
the silicone USB cover is securely positioned enclosing
USB port (5).
TAKING PICTURES
When the glasses are powered on and shooting video,
simply press the on/off button (1) to take still pictures.
The glasses blue LED indicator light (3) will flash letting you
know the picture was taken and saved. Taking pictures will
not interrupt the video recording process and the user now
has the ability to capture photos and video simultaneously.
• Note: Make sure there is adequate light when taking pictures and
the glasses are upright and stable.
FILE UPLOADS
Connect the GoVision Sunglasses with USB cable to a
proper computer USB port. The micro SD card will be
recognized as an external drive. All of your movies and
photos can be accessed in the file folder DCIM.
• Note: Please allow time for your computer to discover the
glasses USB cable in external disk drive when looking to view
video and photo files. If the USB cable is not identified after
2 minutes, ensure the 5-Pin end of the cable is properly secured
to the glasses then remove the USB cable and re-insert all the
way into the computer.
CHARGING
Connect glasses to computer by USB cable to charge
battery. The charging led indicator light (7) will be solid
red during the charging process. Glasses are fully charged
when the charging indicator light (7) shuts off. It will take
up to two hours to obtain a full charge. Please make sure
your GoVision is fully charged before use.
• Note: It is recommended that you only charge the GoVision
glasses for no more than 2 1/2 Hours at one time.
