GPX D112B User manual
POWER
DVD / CD PLAYER
Plug the attached AC cord into a standard AC
power outlet to power the DVD player.
120V ~ 60Hz
Pb/CbY Pr/Cr VIDEO
L R COAXIAL
AUDIO OUT DIGITAL VIDEO OUT
USER’S GUIDE
V:476-02
RCA Stereo Audio
Outputs
Component Video
Outputs
D112B DVD Player
Warning: Changes or modications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• The apparatus shall not be exposed to dripping or splashing and that no objects lled with
liquids, such as vases, shall be placed on apparatus.
L’appareilnedoitpasêtreexposéauxécoulementsouauxéclaboussuresetaucunobjetne
contenantdeliquide,telqu’unvase,nedoitêtreplacésurl’objet.
• Main plug is used as disconnect device and it should remain readily operable during intended
use. In order to disconnect the apparatus from the mains completely, the mains plug should
be disconnected form the mains socket outlet completely.
Laprisedusecteurnedoitpasêtreobstruéeoudoitêtrefacilementaccessiblependantson
utilisation.Pourêtrecomplètementdéconnectédel’alimentationd’entrée,laprisedoitêtre
débranchéedusecteur.
• Battery shall not be exposed to excessive heat such as sunshine, re or the like.
Lespilesnedoiventpasêtreexposéesàdefortechaleur,telqu’àlalumièredusoleil,aufeu
ouautreschosesdesemblable.
• Caution marking is located at the rear or bottom of the apparatus.
Attentionmarquageestsituésurlepaneauarrièreouinférieurdel’unité.
• The marking information is located at the rear or bottom of apparatus.
Lemarquageestsituésurlepaneauarrièreouinférieurdel’unité.
1. Read these Instructions.
2. Keep these Instructions.
3. Heed all Warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
ampliers) that produce heat.
9. Do not defeat the safety purpose of the polarized or
grounding - type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The
wide blade or the third prong are provided for your
safety. When the provided plug does not t into your
outlet, consult an electrician for replacement of the
obsolete outlet.
10. Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11. Only use attachments/accessories specied by the
manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table
specied by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury
from tip-over. Unplug this apparatus during lightning
storms or when unused for long periods of time.
13. Refer all servicing to qualied
service personnel. Servicing is
required when the apparatus has
been damaged in any way, such
as power-supply cord or plug is
damaged, liquid has been spilled
or objects have fallen into the
apparatus, the apparatus has
been exposed to rain or moisture,
does not operate normally, or has
been dropped.
• CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE
SLOT, FULLY INSERT.
• WARNING:To reduce the risk of re or electric shock, do not expose this apparatus to rain or
moisture.
• AVERTISSEMENT: Pour réduire le risque d’incendie ou de choc électrique, ne pas exposer cet
appareil sous la pluie et l’humidité.
• CAUTION: Use of controls or adjustments or performance of procedures other than those specied
may result in hazardous radiation exposure.
• WARNING: Changes or modications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
• WARNING: Do not place the unit on top of any soft, porous, or sensitive surfaces to avoid
damaging the surface. Use a protective barrier between the unit and surface to protect the surface.
• WARNING: Use of this unit near uorescent lighting may cause interference regarding use of
the remote. If the unit is displaying erratic behavior move away from any uorescent lighting, as
it may be the cause.
• CAUTION:Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
• PRÉCAUTION:Dangerd’explosionsilespilessontremplacéesdefaçonincorrect.Remplacerles
pilesseulementparlemêmetypedepileoul’équivalent.
• WARNING: There is a danger of explosion if you attempt to charge standard Alkaline batteries in
the unit. Only use rechargeable NiMH batteries.
• WARNING: The remote control’s button cell battery contains mercury. Do not put in the trash,
instead recycle or dispose of as hazardous waste
• WARNING:Lithium batteries, like all rechargeable batteries are recyclable and should be recycled
or disposed of in normal household waste. Contact your local government for disposal or recycling
practices in your area. They should never be incinerated since they might explode.
• WARNING: Shock hazard - Do Not Open.
• AVIS:RISQUEDECHOCÉLECTRIQUE-NEPASOUVRIR
Mains plug is used as disconnect device and it should remain readily operable during intended
use. In order to disconnect the apparatus from the mains completely, the mains plug should be
disconnected form the mains socket outlet completely.
Laprisedusecteurestutilisépourdéconnecterlesystème.
Laprisedusecteurnedoitpasêtreobstruéeoudoitêtrefacilementaccessiblependantson
utilisation.Pourêtrecomplètementdéconnectédel’alimentationd’entrée,laprisedoitêtre
débranchéedusecteur.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
Nomezclebateríasviejasynuevas.
Nomezclebateríasalcalinas,estándar(carbono-zinc)orecargables(ni-cad,ni-mh,etc.).
WARNING: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
ATTENTION
RISQUE D' ÉLECTROCUTION
NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and maintenance
(servicing) instructions in the literature
accompanying the appliance.
This symbol indicates that this product
incorporates double insulation between hazardous
mains voltage and user accessible parts.
The lightning ash with arrowhead symbol,
within an equilateral triangle, is intended to alert
the user to the presence of uninsulated “dangerous
voltage” within the product’s enclosure that may
be of sufcient magnitude to constitute a risk of
electric shock to persons.
IMPORTANT SAFETY INSTRUCTIONS
Introduction and Setup
FCC Warnings
Power
Requires 2 AAA batteries (not included).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or
rechargeable (ni-cad, ni-mh, etc) batteries
Remote
Additional Warnings
WARNINGS AND PRECAUTIONS
120V ~ 60Hz
Pb/CbY Pr/Cr VIDEO
L R COAXIAL
AUDIO OUT DIGITAL VIDEO OUT
OPEN/CLOSE
MUTE
AUDIOSTOPDVD/USBSUBTITLE
TITLEOSD
VIDEOWIDEZOOMANGLE
SETUP
ENTER
MENU
VOLUME
GOTORANDOMCLEARPROG
STEPSLOWA-BREPEAT
Composite Video
Output
Power
Press to turn the DVD
player off or on.
Open/Close
Press to open or close
the Disc Drawer.
Disc Drawer
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.gpx.com Customer Service: 1-888-999-4215
Email Support: [email protected], Email Parts: [email protected]
Copyright © 2012 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners. Specications are subject to change without notice.
Open/Close
Number Keypad
Menu
Press to access
the main
menu on a
loaded DVD.
Skip
Search
OSD
DVD/USB
Press to enter to
DVD/USB mode.
Press the Up/
Down and Enter
buttons to make
a selection.
Subtitle
Zoom
Angle
A-B
Repeat
Prog
Volume
Mute
Setup
Press to access
the setup menu.
Arrows/Enter
Play/Pause
Stop
Title
Audio
Wide
Video
Press to switch
between
CVBS+YUV or
CVB+P-Scan.
Slow
Step
Goto
Random
Clear
Power
Skip
Press to skip forwards
or backwards through a
loaded disc.
Play/Pause
Press to play or pause
a loaded DVD.
USB Port
Coaxial Digital Audio
Output
120V ~ 60Hz
Pb/CbY Pr/Cr VIDEO
L R COAXIAL
AUDIO OUT DIGITAL VIDEO OUT
1. Connect the DVD player to a television
and press the Power button to turn the
DVD player on.
2. Press the Open/Close button to open the
Disc Drawer.
3. Load a disc into the Disc Drawer, label
side facing up, and press the Open/Close
button to close the Disc Drawer.
1. Follow the instructions for Loading a Disc
and Playing a Loaded Disc.
2. Press the Prog button on the remote.
3. Press the Arrow buttons to highlight the
blanks under title, chapter, or track.
4. Use the Number Keypad on the remote
to enter in the title, chapter, or track
number you wish to program.
5. Highlight and press the on-screen Play
button using the Enter button.
6. To cancel the program, press the Clear
button on the remote.
DVD and CD Connecting Video and Audio
Loading a Disc
1. Follow the instructions for Loading a Disc.
2. If the disc does not begin playing
automatically, press the Play/Pause
button.
Playing a Loaded Disc
Programming a Loaded Disc
1. Load a JPEG photo disc into the player
by following the instructions for Loading
a Disc.
A slide show of JPEG photos from the CD
will begin playing automatically.
2. Press the Stop button to access a le
view of the loaded JPEG disc.
3. Use the Arrows/Enter buttons on the
remote to select and view photos.
Playing a JPEG CD
Press the Stop button on the remote twice.
In order to access all of the features of the DVD
setup menu, the DVD player needs to be fully
stopped.
Press the Setup button on the remote.
Access the DVD Setup Menu
Television
Composite Video Input
Note: Before making or changing any connections, make sure that all the devices are
disconnected from the power outlet.
Note: Both video and audio connections must be made from the DVD player to your television.
Requires a composite video cable
(included)
1. Plug the included RCA audio/video cable
into the Composite Video Output (yellow)
on the DVD player and the composite
video input (yellow) on a television.
2. Plug the remaining plugs on the included
RCA audio/video cable into the RCA
Stereo Audio Outputs (red and white) on
the DVD player and the RCA stereo audio
inputs (red and white) on a television.
3. Adjust the television’s input setting to
correspond to the inputs used when
connecting the DVD player.
Composite Video Output (Good)
120V ~ 60Hz
Pb/CbY Pr/Cr VIDEO
L R COAXIAL
AUDIO OUT DIGITAL VIDEO OUT
Television
Component Video Inputs
Requires a component video cable (not
included).
1. Plug a component video cable into
the Component Video Outputs (green,
blue, red) on the DVD player and the
component video input (green, blue, red)
on a television.
2. Plug the included RCA audio/video cable
into the RCA Stereo Audio Outputs (red
and white) on the DVD player and the RCA
stereo audio inputs (red and white) on a
television.
3. Adjust the television’s input setting to
correspond to the inputs used when
connecting the DVD player.
Component Video Output (Better)
For Warranty Information and the most up-to-date version of this User’s Guide, go to www.gpx.com Customer Service: 1-888-999-4215
Email Support: [email protected], Email Parts: [email protected]
Copyright © 2012 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners. Specications are subject to change without notice.
To download this User’s Guide in English,
Spanish, or French, or to get answers
to frequently asked questions, visit the
support section at: www.gpx.com
Para descargar este Manual del Usuario en
inglés, español y francés, o para obtener
respuestas a preguntas frecuentes, visite
la sección de apoyo en www.gpx.com
Pour télécharger ce guide de l’utilisateur
en anglais, espagnol ou français, ou pour
obtenir des réponses à des questions
fréquemment posées, consultez la rubrique
d’assistance sur www.gpx.com
International Support
120V ~ 60Hz
Pb/CbY Pr/Cr VIDEO
L R COAXIAL
AUDIO OUT DIGITAL VIDEO OUT
Requires a coaxial digital audio cable (not
included).
1. Plug a coaxial digital audio cable into the
Coaxial Digital Audio Output on the DVD
player and the coaxial digital audio input
on a television or stereo system.
2. Adjust the television or stereo system’s
input setting to correspond to the input
used when connecting the DVD player.
Coaxial Digital Audio Output
Audio System
Coaxial Digital Audio Input
1. Load a USB thumb drive
into the USB Port.
2. Press the DVD/USB button to
enter DVD/USB Mode.
3. Use the Up/Down and Enter
buttons to select content from the
connected USB thumb drive.
USB Drive
POWER
DVD / CD PLAYER
Other manuals for D112B
1
Other GPX DVD Player manuals
