GPX D200B User manual

Customer Support: 1-888-999-4215GPX
Quickstart Guide
Video/Audio Connectivity
Playing Video/Audio Through a Connected TV
DVD player Television
Video
Output
Video
Input
Composite Video and RCA Stereo Audio
Pb/CbY Pr/Cr
R COAXIAL
AUDIOOUT DIGITAL
L VIDEO
VIDEOOUT
120V~ 60H z
Audio
Inputs
Audio
Outputs
Note: Please make sure the power is off before making any connections.
Note: Depending on your
television manufacturer this
input may be yellow or green.
Pb/CbY Pr/Cr
R COAXIAL
AUDIO OUT DIGITAL
L VIDEO
VIDEO OUT
120V ~ 60Hz
1. Conrm the video out connection type
from the DVD player to the TV. There are
two types of outputs on the DVD player.
Use the Composite (Yellow) output on
the DVD player to connect to the Yellow
video input on the TV (Depending on your
television manufacturer this input may be
yellow or green ) using the included video
cable.
2. Select the INPUT type on the TV from the
remote. Select the input that is the same
as what was used in the initial hook up as
outlined in point
3. If you still have an issue, some television
models require that each Video INPUT
is activated in the television’s setup
menu before any video signals can pass.
Consult with your television manufactures
user manual for further details.
1. Use the Composite Video Output to
send video from the DVD player to a
television.
2. Requires a composite video cable
(included).
3. Use the included composite video cable
to connect the Composite Video Output
to a composite video input on a television.
4. Adjust the connected televisions input
setting to match the input used in the
previous step.
Composite Video Output
Troubleshooting

Customer Support: 1-888-999-4215GPX
Quickstart Guide
1. Press the Open/Close button to open the
Disc Drawer.
2. Load a disc into the DVD player, label side
facing up.
3. Press the Open/Close button to close the
Disc Drawer.
4. After a disc is loaded, it will begin playing
automatically.
Disc Errors or Wrong Disc:
1. Conrm the disc is loaded into the tray label side up.
2. Conrm the disc is not scratched or damaged.
3. Conrm the disc is not a burned or copied disc as an incorrect format can affect playback.
4. Conrm the disc is a region 1 disc. Note: This player is programed to only support region 1
disc.
5. Some Box rental discs have been used many times and become corrupted or damaged.
This will cause the DVD player to state that the disc is unreadable. If that occurs, you should
return the rental disc and have it replaced.
Remote Control Issues:
1. Conrm the batteries are inserted correctly. Check the + or – on the battery and conrm
with the diagram in the IB or in the battery compartment of the remote to conrm they are
inserted correctly.
2. If you are experiencing slow or no response from the remote, replace the batteries with new
“AAA” batteries.
3. Check remote functionality by observing the remote IR light through the lens of a digital
camera, in low lighting, while a button on the remote is pressed. Note: You should see a blue
light ashing in the remote IR LED
4. To reset the remote, remove the batteries and press and hold the power button for at least 30
seconds. Then reinsert the batteries.
DVD and CD Remote
Loading a Disc
Troubleshooting
Troubleshooting
1. Follow the instructions for Loading a Disc.
2. If the disc does not begin playing
automatically, press the Play/Pause
button.
Playing a Loaded Disc