Graco SimpleSwitch User manual

• Owners Manual
SimpleSwitch™
©2011 Graco PD162120B 11/11

Highchair
Feeding Booster
attached to chair
This product can be used in the following modes:
2

Failure to follow these warnings and the
assembly instructions could result in serious injury or death.
3
sPLEASE SAVE OWNER’S
MANUAL FOR FUTURE USE.
sFOR YOUR CHILD’S SAFETY,
read the labels and the owner’s
manual before using product.
sFALL HAZARD Never move or
lift high chair or booster seat with
child in it.
sADULT ASSEMBLY REQUIRED.
sNEVER LEAVE CHILD
UNATTENDED. Always keep your
child in view.
sPREVENT SERIOUS INJURY
OR DEATH FROM FALLS OR
SLIDING OUT. Always use seat
belt. Secure your child at all
times with the restraint system
provided, either in the reclining
or upright position. The tray is
not designed to hold your child
in the product. It is
recommended that the product
be used in the upright position
only by children capable of
sitting upright unassisted.
sDO NOT FORCE TRAY
against child. Use only the three
adjustment positions. Be sure
both adjustment fingers are
engaged in armrest slots.
sSTRANGULATION HAZARD:
Do not place product in any
location where there are cords,
such as window blind cords,
drapes, phone cords, etc.
sTHIS HIGHCHAIR IS
DESIGNED TO BE USED BY A
CHILD UP TO 3 YEARS OF
AGE. Maximum weight 37
pounds (16.8 kg).
sFOLLOW ASSEMBLY
INSTRUCTIONS CAREFULLY.
If you experience any difficulties,
please contact the Customer
Service Department.
sDISCONTINUE USING YOUR
HIGHCHAIR should it become
damaged or broken.
sPREVENT SERIOUS INJURY OR
DEATH. Do not use in motor
vehicle.
s$/./4!$*534the recline of
product with your child in it.
sALWAYS USE booster straps to
attach feeding booster seat to
any chair. Always ensure straps
are pulled tight.

sIF FEEDING BOOSTER SEAT
CANNOT be securely and safely
attached to the adult chair, do
not use infant/toddler feeding
booster seat with that chair.
sTHIS FEEDING BOOSTER SEAT
is designed to be used by a child
up to 60lbs (27.3kg).
sUSE ONLY SimpleSwitch™
highchair accessories with this
product.
sUNTIL CHILD IS ABLE to get in
and out of the feeding booster
without help (about 2 1/2 years
old), the child should be secured
in the feeding booster seat at all
times by the restraining system.
The tray is not designed to hold
the child in the chair.
sDO NOT USE the booster on a
stool, swivel chair, folding chair
or any other type of chair to
which this booster cannot be
firmly attached. The
recommended type of chair shall
be with four legs, a high
backrest, and a firm seat.

8
This model may not
include some
features shown
below. Check that
you have all the
parts for this model
BEFORE assembling
your product. If any
parts are missing,
call Customer
Service.
No tools required.
Parts list
!,, -/$%,3
2X
#%24!). -/$%,3
2X 2X

9
To Attach Front Legs
1
Grab leg with collar and insert
it firmly into openings in
footrest as shown.
Line up buttons and guide with
channels in opening.
2X 2X
2Push front legs up into footrest
until the collars stop them.
collar

10
Insert front leg assembly into
bottom of seat as shown.
4
SNAP!
3
Align arrows on front legs with
the arrow on the booster base
as shown.

11
5Insert rear legs into bottom of
seat as shown.
SNAP!
To Attach Rear Legs

To remove front legs, press button
on side of seat and pull leg out a
little.
NOTE: DO NOT pull leg out
completely until you have pressed
button on the other side of seat to
release the other leg.
12
To remove rear legs, press buttons
on side of seat as shown.
6
To Remove Legs
7
8

13
Seat Back
9Insert seat back into base of infant
seat.
NOTE: Make sure straps DO NOT
get caught between seat bottom
and back.

14
Squeeze handle to allow rods to
drop into holes.
Turn two pieces over while holding
the seat back in place and CHECK
to make sure the seat back is in
the seat base before inserting pins
into place.
Insert pins through seat hinge past
the tabs.
11 2X
SNAP!
10

15
Attaching Seat Pad
Pull waist straps through openings in
seat pad.
12
13
Insert straps on back of seat pad into
slots in seat back as shown.

16
Pull shoulder straps and crotch strap
through openings in seat pad.
Wrap seat pad over the top of the
infant seat.
14
15
Make sure recline handle is sticking out
the hole in the seat pad.
16

17
Fasten elastic straps on seat pad
to hooks under infant seat as
shown.
18
17
Hook seat pad onto side of seat
back as shown. Repeat on other
side.

18
20
Pull waist straps through openings in
head support.
19 Place head support on top of seat pad.
Head support and Harness covers
(On certain models)
Never use this head support on any
other product.

19
Pull shoulder straps through openings
in head support.
21
22 Slide harness covers onto shoulder
straps.

20
To Use Tray
23 Squeeze release levers on each side of
tray, place tray on seat, and snap into
side tray locks.
SNAP!
To release squeeze release levers on
each side of tray and lift off.
24
To release push button on front of tray.
25
OR/OU/O

21
Tray Cover
26
Attach tray cover by pushing it down
on the tray.
To remove pull up on the back of the
tray.
27
Dishwasher safe.
SNAP!

22
To Recline Seat
Squeeze handle on back of seat
and push down or pull up to
adjust.
28
There are 3 recline positions.
29
WARNING
DO NOT adjust
the seat recline
with the child in
it.

23
4O 3ECURE #HILD
30
 0OINT (ARNESS
WARNING
&ALLING(AZARD
Always use the seat
belt.
31
32