Graco 1812897 User manual

Graco PD202869D 10/14
BlossomTM

Highchair Infant Feeding Booster
(Infant seat attached to Toddler Booster)
Toddler Booster Youth Chair
This product can be used in the following modes:

Failure to follow these warnings and the assembly instructions could result
in serious injury or death.
•PLEASE SAVE OWNER’S MANUAL FOR FUTURE USE.
•ADULT ASSEMBLY REQUIRED.
•NEVER LEAVE CHILD UNATTENDED. Always keep
your child in view.
•NEVER allow a child to push away from table.
•PREVENT SERIOUS INJURY OR DEATH FROM
SLIDING OUT, FALLS, OR TIPPING OVER. Always use
seat belt. Secure your child at all times with the restraint
system provided, either in the reclining or upright position.
The tray is not designed to hold your child in the product.
It is recommended that the product be used in the upright
position only by children capable of sitting upright
unassisted.
•THIS PRODUCT IS DESIGNED AS A highchair for use
with child up to 3 years of age or as a child’s booster seat
for use with a child up to 6 years of age and up to 60 lbs.
•DO NOT FORCE TRAY against child. Use only the three
adjustment positions. Be sure both adjustment fingers are
engaged in armrest slots.
•STRANGULATION HAZARD Do not place product in
any location where there are cords, such as window blind
cords, drapes, phone cords, etc.
•FOLLOW ASSEMBLY INSTRUCTIONS CAREFULLY. If
you experience any difficulties, please contact the
Customer Service Department.
•PREVENT SERIOUS INJURY OR DEATH. Do not use in
motor vehicles.
•DO NOT ADJUST the height or recline of product with
your child in it.
•NEVER USE the infant seat not attached to toddler
booster or youth chair.
•ALWAYS USE booster straps to attach toddler booster
to any chair. Always ensure straps are pulled tight.
•IF TODDLER BOOSTER CANNOT be securely and safely
attached to the adult chair, do not use toddler booster
with that chair.
•UNTIL CHILD IS ABLE to get in and out of the toddler
booster or infant feeding booster without help (about 2
1⁄2 years old), the child should be secured in the booster
seat at all times by the restraining system. The tray is not
designed to hold the child in the chair.
•THIS TODDLER BOOSTER is designed to be used by a
child up to 60lbs (27.3kg).
•USE ONLY Blossom highchair accessories with this
product.
•REMOVABLE SEAT BACK INSERT must be used with
child less than 36 months. Always use harness. FOR USE
ONLY with the Blossom youth chair or toddler booster.
•THIS YOUTH CHAIR is designed to be used by a child
up to 60lbs (27.3kg).
•YOUTH CHAIR without removable seat back insert is
only for child 36 months and older.

ALL MODELS
2X
This model may not include some features shown below. Check that
you have all the parts for this model BEFORE assembling your
product. If any parts are missing, call Customer Service.
3X
Parts list
Phillips screwdriver required.
(CERTAIN MODELS)
Tray Insert
(2 on certain models)

1Insert wheels into rear leg of highchair in the holes
provided.
SNAP!
Assembling Youth Chair
2X
2Lay youth chair flat on the floor. Insert rear leg as
shown.
3
The buttons on side will snap into place when secured.
If you need to remove leg for storage, press button in
and pull up.
SNAP!

1
3
2
Insert foot rest into bottom of seat as shown.
4
Attach footrest cover by inserting into bottom of seat
as shown.
Attach footrest cover by screwing 3 Phillips head
screws into footrest as shown.
Footrest
3X
Push footrest toward front of seat.

5
7
6
Hold footrest perpendicular to the front of the
highchair.
Insert into one of the 3 height options and rotate foot
rest down to secure.

1
2
Insert seat back into base of infant seat.
NOTE: Make sure straps DO NOT get caught between
seat bottom and back.
Infant Seat Assembly
Squeeze handle to allow rods to drop into holes.
SNAP!

2
3
Attach seat pad to infant seat as shown. Pull waist
straps through openings in seat pad.
Pull shoulder straps and crotch strap through
openings in seat pad.
Seat Pad
1Insert the webbing on the back of the seat pad into
the slots in the seating area.
4
Wrap seat pad over the top of the infant seat.

Snap seat pad flaps into armrest on both sides of
infant seat.
5Make sure recline handle is sticking out the hole in the
seat pad.
7
6
Secure seat pad with hooks at the front of infant seat
as shown.