Graco Pack'n Play User manual

Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE.
See back page for quick set up guide.
Pack ‘n Play®Playard
Reversible Napper & Changer™LX

Failure to follow these warnings and the
instructions could result in serious injury or death.
Setting Up the Playard
• THIS PRODUCT REQUIRES ADULT
ASSEMBLY.
• Keep fingers clear of top corners
during setup. Be sure playard is
completely set up before use.
Check that the four top rails are
completely latched, the center of
the floor is pushed down, the
mattress/pad is flat, the straps are
securely fastened to the
bottom of the unit and the four
corners are tucked under the
stiffeners. Always follow the
instructions in the owner’s manual
to set up the playard.
Using the playard
• The playard is for playing or
sleeping. When used for playing,
never leave child unattended and
always keep child in view. When
used for sleeping, you must still
provide the supervision necessary
for the continued safety of your
child.
• Always keep the playard away
from hazards in the area that may
injure your child.
• When child is able to pull to
standing position, remove large
toys and other objects that could
serve as steps for climbing out.
• Stop using this product when your
child reaches 35 inches (89 cm)
in height, weighs more than 30 lb
(14 kg), or is able to climb out.
• Do not modify playard or add any
attachments that are not
listed in the owner’s manual,
including an add-on bassinet.
• Child can become entrapped and
die when improvised netting or
covers are placed on top of a
playard. Never add such items to
confine child in playard.
• NEVER leave child in product with
side lowered. Be sure side is in
raised and locked position
whenever child is in product.
• If refinishing, use a nontoxic finish
specified for children’s products.
Avoiding Suffocation Hazards
• Unlike cribs that have rigid sides,
the playard has flexible sides.
As a result, the playard mattress/
pad is specially designed to
prevent suffocation. The playard
mattress/pad has a solid base, a
certain length and width, and is
less than one inch thick in order to
meet safety standards. Using a
thicker or a different sized
mattress/pad may allow a child’s
head to get between mattress/pad
and the side of the playard
causing suffocation.
•Infants can suffocate
• In gaps between a mattress
too small or too thick and
products sides
• On soft bedding.
NEVER add a mattress,
pillow, comforter or padding.
Use ONLY mattress pad
provided by Graco.

• To reduce the risk of SIDS,
pediatricians recommend healthy
infants be placed on their backs to
sleep, unless otherwise advised by
your physician.
• Never use plastic shipping bags or
other plastic film as mattress
covers not sold and intended for
that purpose. They can cause
suffocation.
• NEVER use a water mattress with
the playard.
Avoiding Strangulation
Hazards
• Strings and cords can cause
strangulation. Keep strings and
cords away from child.
• NEVER place the playard near a
window where cords from blinds
or drapes can strangle a child.
• NEVER hang strings on or over the
playard.
• NEVER place items with a string
around a child’s neck, such as
hood strings, pacifier cords, etc.
• NEVER attach strings to toys.
• This product is not intended for
commercial use.

2-A Parts list
FEATURES ON CERTAIN MODELS
ALL MODELS
This model may not include some
features shown below. Check that
you have all the parts for this model
BEFORE assembling your product. If
any parts are missing, call Customer
Service.
No tools required.
2X
AB C
D
EF
G
HI
JK
L
M

3-A Playard Setup
3. Pull up on side rails in middle
above push button until all four
sides are locked. DO NOT push
center down yet.
1. Disconnect straps holding
mattress around playard.
2. Remove mattress from around
playard.
SNAP!

SNAP!
4. When setting up, lock rails
BEFORE lowering center.
Be sure top rails have become
rigid. If not, pull up again until
they are rigid. If top rails do not
latch, lift the center of the floor
higher.
CHECK that fabric covers
corners.
5. Hold one end of the unit up and
push the center of the floor down
until locked securely into place.
6. Always use mattress/pad soft
side up.

SNAP!
7. Pull the two hook and loop tabs
under mattress/pad through the
slotted holes and attach to hook
and loop patch on bottom of
playard.
8. Pull the four snap straps on
corners of playard mattress
through bottom of playard. Wrap
around the tube and fasten snap
onto the tube. Repeat on all
corners.
9. Tuck four corners of mattress/pad
under corner stiffeners.

WARNING
SUFFOCATION HAZARD Infants have suffocated:
• In gaps between extra padding and side of the bassinet, and
• On soft bedding.
Use ONLY mattress/pad provided by Graco. NEVER add a pillow,
comforter or another mattress for padding.
• FALL HAZARD: To help prevent falls, do not use this product when
the infant begins to push up on hands and knees or weighs over
15 lb (6.8 kg), whichever comes first.
• Use bassinet with only one child at a time.
• Never place a child under the bassinet.
• The bassinet must be fully assembled and installed, including four
metal tubes, eight clips and mattress/pad, before using. Do not
modify bassinet or add any attachments that are not listed in the
owner’s manual.
• DO NOT store the bassinet in the playard while in use.
• To help prevent heat build-up inside the playard and to avoid
overheating your child, when using the bassinet DO NOT use an
outdoor canopy.
• To reduce the risk of SIDS, pediatricians recommend healthy infants
be placed on their backs to sleep, unless otherwise advised by your
physician.
• If a sheet is used with the pad use only the one provided by Graco
or one specifically designed to fit the dimensions of the bassinet.
• Never place child in bassinet while napper/changer is attached.
3-B Bassinet Set Up

1. You will need to remove the
mattress/pad from the bottom
of the playard to use inside your
bassinet.
2. Make sure to fasten the
bassinet clips to the playard
Always press down on the left
side of the clip, then the right as
shown. Repeat on all eight clips.

3. Insert tapered end of bar into end
of other bar with hole in it. Repeat
with other set of bars.
CHECK: Tubes MUST be
assembled before placing
mattress/pad in bassinet.
4. Insert the mattress/pad soft side
up into the playard, making sure
the hook and loop patches on
bottom of mattress attaches to
matching hook and loop patches
on the bassinet.