Graco TableFit User manual

Graco PD215128D 5/13
TableFit TM
Owners Manual

Failure to follow these warnings and the
assembly instructions could result in serious injury or death.
sPLEASE SAVE OWNER’S
MANUAL FOR FUTURE USE.
sADULT ASSEMBLY REQUIRED.
sNEVER LEAVE CHILD
UNATTENDED. Always keep
your child in view.
sPREVENT SERIOUS INJURY
OR DEATH FROM FALLS OR
SLIDING OUT. Always use seat
belt. Secure your child at all
times with the restraint system
provided, in either the reclining
or upright position. The tray is
not designed to hold your
child in the highchair. It is
recommended that the highchair
be used in the upright position
only by children capable of
sitting upright unassisted.
sDO NOT FORCE TRAY
against child. Use only the three
adjustment positions. Be sure
both adjustment fingers are
engaged in armrest slots.
sSTRANGULATION HAZARD:
Do not place highchair in any
location where there are cords,
such as window blind cords,
drapes, phone cords, etc.
sTHIS HIGHCHAIR IS
DESIGNED TO BE USED BY
A CHILD UP TO 3 YEARS
OF AGE. Maximum weight
40 pounds (18.1 kg).
sFOLLOW ASSEMBLY
INSTRUCTIONS CAREFULLY.
If you experience any difficulties,
please contact the Customer
Service Department.
sDISCONTINUE USING YOUR
HIGHCHAIR should it become
damaged or broken.

This model may not include some features shown below. Check that
you have all the parts for this model BEFORE assembling your
product. If any parts are missing, call Customer Service.
Philips Screwdriver
required.
0ARTSLIST 
!##%33/2)%3/.#%24!).-/$%,3
Tray Insert
(2 on certain models)
!,,-/$%,3
2X

3EATASSEMBLY
1
Flip seat upside down.
Insert footrest into seat
until it snaps into place.
Secure footrest to seat
using a Philips head
screwdriver and provided
screws.
2
2X

1Flip seat over.
Hold seat pad up out of
way of slots. Slide pegs on
seat back down channel.
DO NOT press pegs into
holes until Step 3.
!TTACHING"ACKREST
Hole Peg
Channel

Pull seat pad up in order to
press the pegs into the
holes at the bottom of the
channel.
Recline backrest all the way
back.
3
Squeeze recline handle and
guide wire into groove.
Wire
Groove
SNAP!
2
SNAP!

Insert slotted leg post through
the frame of the seat, with logo
facing out and the numbered
leg on the side with window.
Repeat with other leg.
Make sure to squeeze button to
choose one of the other height
options.
1
2
)NSERTINGLEGS

&RONTLEGS
Make sure the buttons snap
into holes.
1
2
Insert “U” tube with wheels
into the front leg tubes.
SNAP!
SNAP!

Insert other “U” tube into
the rear tubes until they
snap into place.
Attaching Rear Legs
!TTACHING&OOTREST
Attach footrest to one of the
receiving slots as shown.
SNAP!
SNAP!

Attaching Seat Pad
Insert the elastic straps, located on
the back of the pad, through the
slots in the seat area and pull up
on pad to make sure its secure.
1
2