Green Brook THP1-C User manual

THP1-C Simplified Instructions

Setting current Day and Time -
Press Clock Button.
Press + or – button to adjust hour. Press OK/Enter button to confirm
Press + or – button to adjust minutes. Press Ok/Enter button to confirm.
The Da is flashing. Press + or – button to adjust Da . Press Ok/Enter button
to confirm.
To View programs –
Press program button.
You can scroll through each hour of the da b pressing + or – button.
You will see that each hour is set to either CT or ET
If ou press ok/enter button it will scroll to the next da .
There is a pre set program alread set – see table below
To change a preset program –
Press Program button to enter program mode.
Press ok/enter button to select da of the week.
Press + or – button to scroll though hours in the da .
Press the CT button or ET button for each hour of the da .
Important ote –
Do not set the beginning and end of the program to 0:00 due to the
thermostat needing this time for its reference use.
Therefore ou must set the beginning or end time at 23:00 or 1:00.

Changing the CT or ET Temperature
Press the Temp button.
Press CT button or ET button
Press + or – to adjust temp
Press ok/enter button to confirm setting.
Setting Vacation Temperature or Permanent override
Press Vacation button.
Use + or – button to adjust amount of da s vacation (0– 99 da s)
If ou choose to leave as ‘- - ‘this will be a permanent override.
Press ok/enter button to confirm.
To cancel vacation / permanent override – Press CT or ET button or even
power button to turn unit off.
Setting Temporary manual override temperature
This function allows ou to change the present temperature for a set
period of between 1 to 48 hours.
Press + or – button to set required temperature.
Press ok/enter button to confirm.
Press + or – to set number of hours.
Press ok/enter button to confirm.
(Press CT or ET button to exit)
Setting Temporary override program temperature –
Function allows ou to temporaril override the CT temp from the ET temp
settings, until next CT setting (or vice versa).
If unit is running at CT program period.
Press ET Button to change CT to ET setting (until next CT program period)
Press + or – to set temperature
Press ok/enter to confirm
Set number of hours override

If unit is running at ET program period.
Press CT Button to change ET to CT setting (until next ET program period).
Press + or – to set temperature
Press ok/enter to confirm
Set number of hours override
IMPORTANT
This unit should be installed to current IEE wiring regulations if in doubt
consult a qualified electrician.