Grieve HONEYWELL UDC3200 Assembly instructions

BASIC OPERATION –UDC3200
REV 0 –24/03/2010 11:54:00 Page 1 of 2
Z:\Electrical\INSTRUCT\INSTRUMENT\HONEYWELL\UDC3200\BASIC OPERATION - UDC3200.doc
HONEYWELL UDC3200 KEYS
A. CHANGING THE SET POINT
1. Press until Upper Display shows the PV Value and the Lower
Display shows SP.
2. Press or to change the set point.
3. Press to accept the change.
B. RUNNING A PROFILE (IF APPLICABLE)
For information on how to configure a profile, refer to UDC3200 User Manual, pages 125-131.
1. Press to start a profile. “R” displays in Upper Display to indicate a
profile is running.
SETUP KEY
(SCROLLS THROUGH
CONFIGURATION GROUPS)
UP AND DOWN ARROW KEYS
(INCREASE AND DECREASE)
FUNCTION KEY
(SELECTS FUNCTIONS WITHIN
EACH CONFIGURATION GROUP
RUN/HOLD KEY
(START/HOLD PROFILE
OR TIMER)
MAN/AUTO KEY
(SELECTS BETWEEN
MANUAL AND AUTO MODE)
LOWER DISPLAY KEY
(RETURNS CONTROLLER TO
NORMAL DISPLAY FROM SETUP)
SP SELECT KEY
(SCROLLS THROUGH
SETPOINTS)

BASIC OPERATION –UDC3200
REV 0 –24/03/2010 11:54:00 Page 2 of 2
Z:\Electrical\INSTRUCT\INSTRUMENT\HONEYWELL\UDC3200\BASIC OPERATION - UDC3200.doc
C. TO HOLD A PROFILE (IF APPLICABLE)
1. Press to hold a profile. “H” displays in Upper Display to indicate a
profile is held at the current setpoint.
D. PERFORMING ACCUTUNE
1. Press until ACCUTUNE is shown on the lower display.
2. Press until ACCUTUNE is shown on the lower display. Press
to enable Accutune (TUNE).
3. Press to return to MAIN MENU.
4. Set the controller to the desired set point.
5. Press to return until TUNE OFF is shown on the lower display.
Press until DoFast is shown on the lower display.
6. Press to return to MAIN MENU.“T” displays in Upper Display as
long as Accutune is in process. Once complete, lower display will show
TUNE OFF and PID values will be filled in under TUNING menu.